phy-mode = "rmii";
};
+&phy_sel {
+ rmii-clock-ext;
+};
+
&i2c0 {
status = "okay";
pinctrl-names = "default";
clocks = <&qspi_gfclk_div>;
clock-names = "fck";
num-cs = <4>;
- interrupts = <0 343 0x4>;
status = "disabled";
};
#size-cells = <1>;
status = "disabled";
};
+
+ atl: atl@4843c000 {
+ compatible = "ti,dra7-atl";
+ reg = <0x4843c000 0x3ff>;
+ ti,hwmods = "atl";
+ ti,provided-clocks = <&atl_clkin0_ck>, <&atl_clkin1_ck>,
+ <&atl_clkin2_ck>, <&atl_clkin3_ck>;
+ clocks = <&atl_gfclk_mux>;
+ clock-names = "fck";
+ status = "disabled";
+ };
};
};
&cm_core_aon_clocks {
atl_clkin0_ck: atl_clkin0_ck {
#clock-cells = <0>;
- compatible = "fixed-clock";
- clock-frequency = <0>;
+ compatible = "ti,dra7-atl-clock";
+ clocks = <&atl_gfclk_mux>;
};
atl_clkin1_ck: atl_clkin1_ck {
#clock-cells = <0>;
- compatible = "fixed-clock";
- clock-frequency = <0>;
+ compatible = "ti,dra7-atl-clock";
+ clocks = <&atl_gfclk_mux>;
};
atl_clkin2_ck: atl_clkin2_ck {
#clock-cells = <0>;
- compatible = "fixed-clock";
- clock-frequency = <0>;
+ compatible = "ti,dra7-atl-clock";
+ clocks = <&atl_gfclk_mux>;
};
atl_clkin3_ck: atl_clkin3_ck {
#clock-cells = <0>;
- compatible = "fixed-clock";
- clock-frequency = <0>;
+ compatible = "ti,dra7-atl-clock";
+ clocks = <&atl_gfclk_mux>;
};
hdmi_clkin_ck: hdmi_clkin_ck {
codec {
};
};
+
+ twl_power: power {
+ compatible = "ti,twl4030-power-beagleboard-xm", "ti,twl4030-power-idle-osc-off";
+ ti,use_poweroff;
+ };
};
};
};
&uart3 {
+ interrupts-extended = <&intc 74 &omap3_pmx_core OMAP3_UART3_RX>;
pinctrl-names = "default";
pinctrl-0 = <&uart3_pins>;
};
gpios = <&twl_gpio 18 GPIO_ACTIVE_LOW>;
};
+&twl {
+ twl_power: power {
+ compatible = "ti,twl4030-power-omap3-evm", "ti,twl4030-power-idle";
+ ti,use_poweroff;
+ };
+};
+
&i2c2 {
clock-frequency = <400000>;
};
compatible = "ti,twl4030-audio";
ti,enable-vibra = <1>;
};
+
+ twl_power: power {
+ compatible = "ti,twl4030-power-n900", "ti,twl4030-power-idle-osc-off";
+ ti,use_poweroff;
+ };
};
&twl_keypad {
operating-points = <
/* kHz uV */
- 500000 880000
1000000 1060000
1500000 1250000
>;
obj-$(CONFIG_ARCH_OMAP2) += prm2xxx_3xxx.o prm2xxx.o cm2xxx.o
obj-$(CONFIG_ARCH_OMAP3) += prm2xxx_3xxx.o prm3xxx.o cm3xxx.o
obj-$(CONFIG_ARCH_OMAP3) += vc3xxx_data.o vp3xxx_data.o
-obj-$(CONFIG_SOC_AM33XX) += prm33xx.o cm33xx.o
omap-prcm-4-5-common = cminst44xx.o cm44xx.o prm44xx.o \
prcm_mpu44xx.o prminst44xx.o \
vc44xx_data.o vp44xx_data.o
obj-$(CONFIG_ARCH_OMAP4) += $(omap-prcm-4-5-common)
obj-$(CONFIG_SOC_OMAP5) += $(omap-prcm-4-5-common)
obj-$(CONFIG_SOC_DRA7XX) += $(omap-prcm-4-5-common)
-obj-$(CONFIG_SOC_AM43XX) += $(omap-prcm-4-5-common)
+am33xx-43xx-prcm-common += prm33xx.o cm33xx.o
+obj-$(CONFIG_SOC_AM33XX) += $(am33xx-43xx-prcm-common)
+obj-$(CONFIG_SOC_AM43XX) += $(omap-prcm-4-5-common) \
+ $(am33xx-43xx-prcm-common)
# OMAP voltage domains
voltagedomain-common := voltage.o vc.o vp.o
void am33xx_cm_clkdm_force_sleep(u16 inst, u16 cdoffs);
void am33xx_cm_clkdm_force_wakeup(u16 inst, u16 cdoffs);
-#ifdef CONFIG_SOC_AM33XX
+#if defined(CONFIG_SOC_AM33XX) || defined(CONFIG_SOC_AM43XX)
extern int am33xx_cm_wait_module_idle(u16 inst, s16 cdoffs,
u16 clkctrl_offs);
extern void am33xx_cm_module_enable(u8 mode, u16 inst, s16 cdoffs,
}
#endif
-extern void __init gic_init_irq(void);
extern void gic_dist_disable(void);
extern void gic_dist_enable(void);
extern bool gic_dist_disabled(void);
}
break;
+ case 0xb9bc:
+ switch (rev) {
+ case 0:
+ omap_revision = DRA722_REV_ES1_0;
+ break;
+ default:
+ /* If we have no new revisions */
+ omap_revision = DRA722_REV_ES1_0;
+ break;
+ }
+ break;
+
default:
/* Unknown default to latest silicon rev as default*/
pr_warn("%s: unknown idcode=0x%08x (hawkeye=0x%08x,rev=0x%d)\n",
m0_entry = mux->muxnames[0];
/* First check for full name in mode0.muxmode format */
- if (mode0_len && strncmp(muxname, m0_entry, mode0_len))
- continue;
+ if (mode0_len)
+ if (strncmp(muxname, m0_entry, mode0_len) ||
+ (strlen(m0_entry) != mode0_len))
+ continue;
/* Then check for muxmode only */
for (i = 0; i < OMAP_MUX_NR_MODES; i++) {
{}
#endif
-void __init gic_init_irq(void)
-{
- void __iomem *omap_irq_base;
-
- /* Static mapping, never released */
- gic_dist_base_addr = ioremap(OMAP44XX_GIC_DIST_BASE, SZ_4K);
- BUG_ON(!gic_dist_base_addr);
-
- twd_base = ioremap(OMAP44XX_LOCAL_TWD_BASE, SZ_4K);
- BUG_ON(!twd_base);
-
- /* Static mapping, never released */
- omap_irq_base = ioremap(OMAP44XX_GIC_CPU_BASE, SZ_512);
- BUG_ON(!omap_irq_base);
-
- omap_wakeupgen_init();
-
- gic_init(0, 29, gic_dist_base_addr, omap_irq_base);
-}
-
void gic_dist_disable(void)
{
if (gic_dist_base_addr)
soc_ops.enable_module = _omap4_enable_module;
soc_ops.disable_module = _omap4_disable_module;
soc_ops.wait_target_ready = _omap4_wait_target_ready;
- soc_ops.assert_hardreset = _omap4_assert_hardreset;
- soc_ops.deassert_hardreset = _omap4_deassert_hardreset;
- soc_ops.is_hardreset_asserted = _omap4_is_hardreset_asserted;
+ soc_ops.assert_hardreset = _am33xx_assert_hardreset;
+ soc_ops.deassert_hardreset = _am33xx_deassert_hardreset;
+ soc_ops.is_hardreset_asserted = _am33xx_is_hardreset_asserted;
soc_ops.init_clkdm = _init_clkdm;
} else if (soc_is_am33xx()) {
soc_ops.enable_module = _am33xx_enable_module;
},
};
+/*
+ * 'ocp2scp' class
+ * bridge to transform ocp interface protocol to scp (serial control port)
+ * protocol
+ */
+/* ocp2scp3 */
+static struct omap_hwmod omap54xx_ocp2scp3_hwmod;
+/* l4_cfg -> ocp2scp3 */
+static struct omap_hwmod_ocp_if omap54xx_l4_cfg__ocp2scp3 = {
+ .master = &omap54xx_l4_cfg_hwmod,
+ .slave = &omap54xx_ocp2scp3_hwmod,
+ .clk = "l4_root_clk_div",
+ .user = OCP_USER_MPU | OCP_USER_SDMA,
+};
+
+static struct omap_hwmod omap54xx_ocp2scp3_hwmod = {
+ .name = "ocp2scp3",
+ .class = &omap54xx_ocp2scp_hwmod_class,
+ .clkdm_name = "l3init_clkdm",
+ .prcm = {
+ .omap4 = {
+ .clkctrl_offs = OMAP54XX_CM_L3INIT_OCP2SCP3_CLKCTRL_OFFSET,
+ .context_offs = OMAP54XX_RM_L3INIT_OCP2SCP3_CONTEXT_OFFSET,
+ .modulemode = MODULEMODE_HWCTRL,
+ },
+ },
+};
+
+/*
+ * 'sata' class
+ * sata: serial ata interface gen2 compliant ( 1 rx/ 1 tx)
+ */
+
+static struct omap_hwmod_class_sysconfig omap54xx_sata_sysc = {
+ .sysc_offs = 0x0000,
+ .sysc_flags = (SYSC_HAS_MIDLEMODE | SYSC_HAS_SIDLEMODE),
+ .idlemodes = (SIDLE_FORCE | SIDLE_NO | SIDLE_SMART |
+ SIDLE_SMART_WKUP | MSTANDBY_FORCE | MSTANDBY_NO |
+ MSTANDBY_SMART | MSTANDBY_SMART_WKUP),
+ .sysc_fields = &omap_hwmod_sysc_type2,
+};
+
+static struct omap_hwmod_class omap54xx_sata_hwmod_class = {
+ .name = "sata",
+ .sysc = &omap54xx_sata_sysc,
+};
+
+/* sata */
+static struct omap_hwmod omap54xx_sata_hwmod = {
+ .name = "sata",
+ .class = &omap54xx_sata_hwmod_class,
+ .clkdm_name = "l3init_clkdm",
+ .flags = HWMOD_SWSUP_SIDLE | HWMOD_SWSUP_MSTANDBY,
+ .main_clk = "func_48m_fclk",
+ .mpu_rt_idx = 1,
+ .prcm = {
+ .omap4 = {
+ .clkctrl_offs = OMAP54XX_CM_L3INIT_SATA_CLKCTRL_OFFSET,
+ .context_offs = OMAP54XX_RM_L3INIT_SATA_CONTEXT_OFFSET,
+ .modulemode = MODULEMODE_SWCTRL,
+ },
+ },
+};
+
+/* l4_cfg -> sata */
+static struct omap_hwmod_ocp_if omap54xx_l4_cfg__sata = {
+ .master = &omap54xx_l4_cfg_hwmod,
+ .slave = &omap54xx_sata_hwmod,
+ .clk = "l3_iclk_div",
+ .user = OCP_USER_MPU | OCP_USER_SDMA,
+};
/*
* Interfaces
&omap54xx_l4_cfg__usb_tll_hs,
&omap54xx_l4_cfg__usb_otg_ss,
&omap54xx_l4_wkup__wd_timer2,
+ &omap54xx_l4_cfg__ocp2scp3,
+ &omap54xx_l4_cfg__sata,
NULL,
};
#define DRA7XX_CLASS 0x07000000
#define DRA752_REV_ES1_0 (DRA7XX_CLASS | (0x52 << 16) | (0x10 << 8))
#define DRA752_REV_ES1_1 (DRA7XX_CLASS | (0x52 << 16) | (0x11 << 8))
+#define DRA722_REV_ES1_0 (DRA7XX_CLASS | (0x22 << 16) | (0x10 << 8))
void omap2xxx_check_revision(void);
void omap3xxx_check_revision(void);
projects / linux-beck.git / commitdiff