A patch from Sukumar Ghorai <s-ghorai@ti.com> changed the
nwires to use caps instead. However, nwires is still
needed for the earlier controller.
Signed-off-by: Tony Lindgren <tony@atomide.com>
Acked-by: Sukumar Ghorai <s-ghorai@ti.com>
Signed-off-by: Ming Lei <tom.leiming@gmail.com>
.max_freq = 24000000,
.dma_mask = 0xffffffff,
.slots[0] = {
- .caps = MMC_CAP_4_BIT_DATA,
+ .wires = 4,
.set_power = n8x0_mmc_set_power,
.set_bus_mode = n8x0_mmc_set_bus_mode,
.get_cover_state = n8x0_mmc_get_cover_state,
struct omap_mmc_slot_data {
- /* 4/8 wires and any additional host capabilities
- * need to OR'd all capabilities (ref. linux/mmc/host.h) */
- u32 caps;
+ /*
+ * 4/8 wires and any additional host capabilities
+ * need to OR'd all capabilities (ref. linux/mmc/host.h)
+ */
+ u8 wires; /* Used for the MMC driver on omap1 and 2420 */
+ u32 caps; /* Used for the MMC driver on 2430 and later */
/*
* nomux means "standard" muxing is wrong on this board, and
host->slots[id] = slot;
mmc->caps = 0;
- if (host->pdata->slots[id].caps & MMC_CAP_8_BIT_DATA)
+ if (host->pdata->slots[id].wires >= 4)
mmc->caps |= MMC_CAP_4_BIT_DATA;
mmc->ops = &mmc_omap_ops;