Fix gpio active flag for the phy reset-gpios property. The line is
active low instead of active high.
Actually, this flags was never used by the macb driver.
Reported-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Cc: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
ethernet-phy@1 {
reg = <0x1>;
- reset-gpios = <&pioE 8 GPIO_ACTIVE_HIGH>;
+ reset-gpios = <&pioE 8 GPIO_ACTIVE_LOW>;
interrupt-parent = <&pioB>;
interrupts = <15 IRQ_TYPE_EDGE_FALLING>;
};
reg = <0x1>;
interrupt-parent = <&pioB>;
interrupts = <31 IRQ_TYPE_EDGE_FALLING>;
- reset-gpios = <&pioE 6 GPIO_ACTIVE_HIGH>;
+ reset-gpios = <&pioE 6 GPIO_ACTIVE_LOW>;
};
};