* Change mtdparts definition on trab board to match current flash map
Patch by Martin Krause, 27 Oct 2005
+* Fix IxEthDB.h to compile again
+ Patch by Stefan Roese, 14 Jun 2006
+
+* Minor cleanup for PCS440EP board
+ Patch by Stefan Roese, 13 Jun 2006
+
* Add MCF5282 support (without preloader)
relocate ichache_State to ram
u-boot can run from internal flash
* @verbatim
IxEthDBPortMap portMap;
- /* clear all ports from port map */
+ // clear all ports from port map
memset(portMap, 0, sizeof (portMap));
- /* include portID in port map */
+ // include portID in port map
portMap[portID / 8] = 1 << (portID % 8);
@endverbatim
*
*/
check_volt_type(dimm_populated, iic0_dimm_addr, num_dimm_banks);
-#if defined(CONFIG_440GX)
+#if defined(CONFIG_440GX) || defined(CONFIG_440EP) || defined(CONFIG_440GR) || defined(CONFIG_440SP)
/*
* Soft-reset SDRAM controller.
*/
*----------------------------------------------------------------------*/
#define CONFIG_SPD_EEPROM /* Use SPD EEPROM for setup */
#undef CONFIG_DDR_ECC /* don't use ECC */
-#define SPD_EEPROM_ADDRESS {0x50, 0x51}
+#define SPD_EEPROM_ADDRESS {0x50}
/*-----------------------------------------------------------------------
* I2C
*----------------------------------------------------------------------*/
#define CONFIG_HARD_I2C 1 /* I2C with hardware support */
#undef CONFIG_SOFT_I2C /* I2C bit-banged */
-#define CFG_I2C_SPEED 400000 /* I2C speed and slave address */
+#define CFG_I2C_SPEED 100000 /* I2C speed and slave address */
#define CFG_I2C_SLAVE 0x7F
-#define CFG_I2C_MULTI_EEPROMS
-#define CFG_I2C_EEPROM_ADDR (0xa8>>1)
+#define CFG_I2C_EEPROM_ADDR (0xa4>>1)
#define CFG_I2C_EEPROM_ADDR_LEN 1
#define CFG_EEPROM_PAGE_WRITE_ENABLE
#define CFG_EEPROM_PAGE_WRITE_BITS 3
CFG_CMD_ASKENV | \
CFG_CMD_DHCP | \
CFG_CMD_DIAG | \
+ CFG_CMD_EEPROM | \
CFG_CMD_ELF | \
CFG_CMD_I2C | \
CFG_CMD_IRQ | \