]> git.karo-electronics.de Git - karo-tx-linux.git/commitdiff
mmc: sdio: reset card during power_restore
authorDaniel Drake <dsd@laptop.org>
Sat, 25 Jun 2011 18:20:11 +0000 (19:20 +0100)
committerChris Ball <cjb@laptop.org>
Sat, 25 Jun 2011 22:52:44 +0000 (18:52 -0400)
mmc_sdio_power_restore() skips some steps that are performed in other
power-related codepaths which are necessary to fully reset the card.
Without this, runtime PM fails for SD8686 SDIO wifi on OLPC XO-1.5.

Signed-off-by: Daniel Drake <dsd@laptop.org>
Signed-off-by: Chris Ball <cjb@laptop.org>
drivers/mmc/core/sdio.c

index 4d0c15bfa51465c91026972417c17652129e09d8..262fff0191779301232fefba02bc8c916e026b33 100644 (file)
@@ -691,15 +691,54 @@ static int mmc_sdio_resume(struct mmc_host *host)
 static int mmc_sdio_power_restore(struct mmc_host *host)
 {
        int ret;
+       u32 ocr;
 
        BUG_ON(!host);
        BUG_ON(!host->card);
 
        mmc_claim_host(host);
+
+       /*
+        * Reset the card by performing the same steps that are taken by
+        * mmc_rescan_try_freq() and mmc_attach_sdio() during a "normal" probe.
+        *
+        * sdio_reset() is technically not needed. Having just powered up the
+        * hardware, it should already be in reset state. However, some
+        * platforms (such as SD8686 on OLPC) do not instantly cut power,
+        * meaning that a reset is required when restoring power soon after
+        * powering off. It is harmless in other cases.
+        *
+        * The CMD5 reset (mmc_send_io_op_cond()), according to the SDIO spec,
+        * is not necessary for non-removable cards. However, it is required
+        * for OLPC SD8686 (which expects a [CMD5,5,3,7] init sequence), and
+        * harmless in other situations.
+        *
+        * With these steps taken, mmc_select_voltage() is also required to
+        * restore the correct voltage setting of the card.
+        */
+       sdio_reset(host);
+       mmc_go_idle(host);
+       mmc_send_if_cond(host, host->ocr_avail);
+
+       ret = mmc_send_io_op_cond(host, 0, &ocr);
+       if (ret)
+               goto out;
+
+       if (host->ocr_avail_sdio)
+               host->ocr_avail = host->ocr_avail_sdio;
+
+       host->ocr = mmc_select_voltage(host, ocr & ~0x7F);
+       if (!host->ocr) {
+               ret = -EINVAL;
+               goto out;
+       }
+
        ret = mmc_sdio_init_card(host, host->ocr, host->card,
                                mmc_card_keep_power(host));
        if (!ret && host->sdio_irqs)
                mmc_signal_sdio_irq(host);
+
+out:
        mmc_release_host(host);
 
        return ret;