]> git.karo-electronics.de Git - karo-tx-linux.git/commitdiff
regulator: core: Request GPIO before creating sysfs entries
authorKrzysztof Adamski <krzysztof.adamski@tieto.com>
Mon, 22 Feb 2016 08:24:00 +0000 (09:24 +0100)
committerMark Brown <broonie@kernel.org>
Mon, 22 Feb 2016 10:51:05 +0000 (19:51 +0900)
regulator_attr_is_visible (which is a .is_visible callback of
regulator_dev_group attribute_grpup) checks rdev->ena_pin to decide if
"status" file should be present in sysfs. This field is set at the end
of regulator_ena_gpio_request so it has to be called before
device_register() otherwise this test will always fail, causing "status"
file to not be visible.

Since regulator_attr_is_visible also tests for is_enabled() op, this
problem is only visible for regulators that does not define this
callback, like regulator-fixed.c.

Signed-off-by: Krzysztof Adamski <krzysztof.adamski@tieto.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
drivers/regulator/core.c

index 744c9889f88d4f83e27c05687ac14427c833c0c5..3c987d76e6841fbdadbc8b15779caf25ce697c45 100644 (file)
@@ -3918,6 +3918,16 @@ regulator_register(const struct regulator_desc *regulator_desc,
                        goto clean;
        }
 
+       if ((config->ena_gpio || config->ena_gpio_initialized) &&
+           gpio_is_valid(config->ena_gpio)) {
+               ret = regulator_ena_gpio_request(rdev, config);
+               if (ret != 0) {
+                       rdev_err(rdev, "Failed to request enable GPIO%d: %d\n",
+                                config->ena_gpio, ret);
+                       goto wash;
+               }
+       }
+
        /* register with sysfs */
        rdev->dev.class = &regulator_class;
        rdev->dev.parent = dev;
@@ -3931,16 +3941,6 @@ regulator_register(const struct regulator_desc *regulator_desc,
 
        dev_set_drvdata(&rdev->dev, rdev);
 
-       if ((config->ena_gpio || config->ena_gpio_initialized) &&
-           gpio_is_valid(config->ena_gpio)) {
-               ret = regulator_ena_gpio_request(rdev, config);
-               if (ret != 0) {
-                       rdev_err(rdev, "Failed to request enable GPIO%d: %d\n",
-                                config->ena_gpio, ret);
-                       goto wash;
-               }
-       }
-
        /* set regulator constraints */
        if (init_data)
                constraints = &init_data->constraints;