playback stops at specified PTS.
Param[0]
Display 0=last frame, 1=black
+ Note: this takes effect immediately, so if you want to wait for a PTS,
+ then use '0', otherwise the screen goes to black at once.
+ You can call this later (even if there is no playback) with a 1 value
+ to set the screen to black.
Param[1]
PTS low
Param[2]
31 Speed:
'0' slow
'1' fast
+ Note: n seems to be limited to 2. Anything higher does not result in
+ faster playback. Instead the host should start dropping frames.
Param[1]
Direction: 0=forward, 1=reverse
+ Note: to make reverse playback work you have to write full GOPs in
+ reverse order.
Param[2]
Picture mask:
1=I frames
7=I, P, B frames
Param[3]
B frames per GOP (for reverse play only)
+ Note: apparently this does not work. For reverse play I can only make it
+ work by selecting I or I and P frames in the Picture mask.
Param[4]
Mute audio: 0=disable, 1=enable
Param[5]
Select audio mode
Param[0]
Dual mono mode action
+ 0=Stereo, 1=Left, 2=Right, 3=Mono, 4=Swap, -1=Unchanged
Param[1]
Stereo mode action:
0=Stereo, 1=Left, 2=Right, 3=Mono, 4=Swap, -1=Unchanged
Counterpart to API 0xD5
Param[0]
Event: 0=Audio mode change between stereo and dual channel
+ Event: 3=Decoder started
+ Event: 4=Unknown: goes off 10-15 times per second while decoding.
+ Event: 5=Some sync event: goes off once per frame.
Param[1]
Notification 0=disabled, 1=enabled
Param[2]