#include "plx9052.h"
#include "8255.h"
-/* Registers for the PCIM-DAS1602/16 and PCIe-DAS1602/16 */
-
-/* DAC Offsets */
-#define ADC_TRIG 0
-#define DAC0_OFFSET 2
-#define DAC1_OFFSET 4
-
-/* AI and Counter Constants */
-#define MUX_LIMITS 0
-#define MAIN_CONN_DIO 1
-#define ADC_STAT 2
-#define ADC_CONV_STAT 3
-#define ADC_INT 4
-#define ADC_PACER 5
-#define BURST_MODE 6
-#define PROG_GAIN 7
-#define CLK8254_1_DATA 8
-#define CLK8254_2_DATA 9
-#define CLK8254_3_DATA 10
-#define CLK8254_CONTROL 11
-#define USER_COUNTER 12
-#define RESID_COUNT_H 13
-#define RESID_COUNT_L 14
+/*
+ * PCI Bar 1 Register map
+ * see plx9052.h for register and bit defines
+ */
+
+/*
+ * PCI Bar 2 Register map (devpriv->daqio)
+ */
+#define PCIMDAS_AI_REG 0x00
+#define PCIMDAS_AI_SOFTTRIG_REG 0x00
+#define PCIMDAS_AO_REG(x) (0x02 + ((x) * 2))
+
+/*
+ * PCI Bar 3 Register map (devpriv->BADR3)
+ */
+#define PCIMDAS_MUX_REG 0x00
+#define PCIMDAS_MUX(_lo, _hi) ((_lo) | ((_hi) << 4))
+#define PCIMDAS_DI_DO_REG 0x01
+#define PCIMDAS_STATUS_REG 0x02
+#define PCIMDAS_STATUS_EOC BIT(7)
+#define PCIMDAS_STATUS_UB BIT(6)
+#define PCIMDAS_STATUS_MUX BIT(5)
+#define PCIMDAS_STATUS_CLK BIT(4)
+#define PCIMDAS_STATUS_TO_CURR_MUX(x) ((x) & 0xf)
+#define PCIMDAS_CONV_STATUS_REG 0x03
+#define PCIMDAS_CONV_STATUS_EOC BIT(7)
+#define PCIMDAS_CONV_STATUS_EOB BIT(6)
+#define PCIMDAS_CONV_STATUS_EOA BIT(5)
+#define PCIMDAS_CONV_STATUS_FNE BIT(4)
+#define PCIMDAS_CONV_STATUS_FHF BIT(3)
+#define PCIMDAS_CONV_STATUS_OVERRUN BIT(2)
+#define PCIMDAS_IRQ_REG 0x04
+#define PCIMDAS_IRQ_INTE BIT(7)
+#define PCIMDAS_IRQ_INT BIT(6)
+#define PCIMDAS_IRQ_OVERRUN BIT(4)
+#define PCIMDAS_IRQ_EOA BIT(3)
+#define PCIMDAS_IRQ_EOA_INT_SEL BIT(2)
+#define PCIMDAS_IRQ_INTSEL(x) ((x) << 0)
+#define PCIMDAS_IRQ_INTSEL_EOC PCIMDAS_IRQ_INTSEL(0)
+#define PCIMDAS_IRQ_INTSEL_FNE PCIMDAS_IRQ_INTSEL(1)
+#define PCIMDAS_IRQ_INTSEL_EOB PCIMDAS_IRQ_INTSEL(2)
+#define PCIMDAS_IRQ_INTSEL_FHF_EOA PCIMDAS_IRQ_INTSEL(3)
+#define PCIMDAS_PACER_REG 0x05
+#define PCIMDAS_PACER_GATE_STATUS BIT(6)
+#define PCIMDAS_PACER_GATE_POL BIT(5)
+#define PCIMDAS_PACER_GATE_LATCH BIT(4)
+#define PCIMDAS_PACER_GATE_EN BIT(3)
+#define PCIMDAS_PACER_EXT_PACER_POL BIT(2)
+#define PCIMDAS_PACER_SRC(x) ((x) << 0)
+#define PCIMDAS_PACER_SRC_POLLED PCIMDAS_PACER_SRC(0)
+#define PCIMDAS_PACER_SRC_EXT PCIMDAS_PACER_SRC(2)
+#define PCIMDAS_PACER_SRC_INT PCIMDAS_PACER_SRC(3)
+#define PCIMDAS_PACER_SRC_MASK (3 << 0)
+#define PCIMDAS_BURST_REG 0x06
+#define PCIMDAS_BURST_BME BIT(1)
+#define PCIMDAS_BURST_CONV_EN BIT(0)
+#define PCIMDAS_GAIN_REG 0x07
+#define PCIMDAS_8254_BASE 0x08
+#define PCIMDAS_USER_CNTR_REG 0x0c
+#define PCIMDAS_USER_CNTR_CTR1_CLK_SEL BIT(0)
+#define PCIMDAS_RESIDUE_MSB_REG 0x0d
+#define PCIMDAS_RESIDUE_LSB_REG 0x0e
+
+/*
+ * PCI Bar 4 Register map (dev->iobase)
+ */
+#define PCIMDAS_8255_BASE 0x00
static const struct comedi_lrange cb_pcimdas_ai_bip_range = {
4, {
struct cb_pcimdas_private *devpriv = dev->private;
unsigned int status;
- status = inb(devpriv->BADR3 + 2);
- if ((status & 0x80) == 0)
+ status = inb(devpriv->BADR3 + PCIMDAS_STATUS_REG);
+ if ((status & PCIMDAS_STATUS_EOC) == 0)
return 0;
return -EBUSY;
}
unsigned int range = CR_RANGE(insn->chanspec);
int n;
unsigned int d;
- unsigned short chanlims;
int ret;
/* only support sw initiated reads from a single channel */
/* configure for sw initiated read */
- d = inb(devpriv->BADR3 + 5);
- if ((d & 0x03) > 0) { /* only reset if needed. */
- d = d & 0xfd;
- outb(d, devpriv->BADR3 + 5);
+ d = inb(devpriv->BADR3 + PCIMDAS_PACER_REG);
+ if ((d & PCIMDAS_PACER_SRC_MASK) != PCIMDAS_PACER_SRC_POLLED) {
+ d &= ~PCIMDAS_PACER_SRC_MASK;
+ d |= PCIMDAS_PACER_SRC_POLLED;
+ outb(d, devpriv->BADR3 + PCIMDAS_PACER_REG);
}
/* set bursting off, conversions on */
- outb(0x01, devpriv->BADR3 + 6);
+ outb(PCIMDAS_BURST_CONV_EN, devpriv->BADR3 + PCIMDAS_BURST_REG);
/* set range */
- outb(range, devpriv->BADR3 + 7);
+ outb(range, devpriv->BADR3 + PCIMDAS_GAIN_REG);
- /*
- * write channel limits to multiplexer, set Low (bits 0-3) and
- * High (bits 4-7) channels to chan.
- */
- chanlims = chan | (chan << 4);
- outb(chanlims, devpriv->BADR3 + 0);
+ /* set mux for single channel scan */
+ outb(PCIMDAS_MUX(chan, chan), devpriv->BADR3 + PCIMDAS_MUX_REG);
/* convert n samples */
for (n = 0; n < insn->n; n++) {
/* trigger conversion */
- outw(0, devpriv->daqio + 0);
+ outw(0, devpriv->daqio + PCIMDAS_AI_SOFTTRIG_REG);
/* wait for conversion to end */
ret = comedi_timeout(dev, s, insn, cb_pcimdas_ai_eoc, 0);
return ret;
/* read data */
- data[n] = inw(devpriv->daqio + 0);
+ data[n] = inw(devpriv->daqio + PCIMDAS_AI_REG);
}
/* return the number of samples read/written */
struct cb_pcimdas_private *devpriv = dev->private;
unsigned int chan = CR_CHAN(insn->chanspec);
unsigned int val = s->readback[chan];
- unsigned int reg = (chan) ? DAC1_OFFSET : DAC0_OFFSET;
int i;
for (i = 0; i < insn->n; i++) {
val = data[i];
- outw(val, devpriv->daqio + reg);
+ outw(val, devpriv->daqio + PCIMDAS_AO_REG(chan));
}
s->readback[chan] = val;
* Analog Input Mode Switch on the board. The board can
* have 16 single-ended or 8 differential channels.
*/
- status = inb(devpriv->BADR3 + 2);
- return status & 0x20;
+ status = inb(devpriv->BADR3 + PCIMDAS_STATUS_REG);
+ return status & PCIMDAS_STATUS_MUX;
}
static bool cb_pcimdas_is_ai_uni(struct comedi_device *dev)
* Analog Input Polarity Switch on the board. The
* inputs can be set to Unipolar or Bipolar ranges.
*/
- status = inb(devpriv->BADR3 + 2);
- return status & 0x40;
+ status = inb(devpriv->BADR3 + PCIMDAS_STATUS_REG);
+ return status & PCIMDAS_STATUS_UB;
}
static int cb_pcimdas_auto_attach(struct comedi_device *dev,
s = &dev->subdevices[2];
/* digital i/o subdevice */
- ret = subdev_8255_init(dev, s, NULL, 0x00);
+ ret = subdev_8255_init(dev, s, NULL, PCIMDAS_8255_BASE);
if (ret)
return ret;
projects / karo-tx-linux.git / commitdiff