ixgbe_configure_srrctl(adapter, ring);
ixgbe_configure_rscctl(adapter, ring);
+ /* If operating in IOV mode set RLPML for X540 */
+ if ((adapter->flags & IXGBE_FLAG_SRIOV_ENABLED) &&
+ hw->mac.type == ixgbe_mac_X540) {
+ rxdctl &= ~IXGBE_RXDCTL_RLPMLMASK;
+ rxdctl |= ((ring->netdev->mtu + ETH_HLEN +
+ ETH_FCS_LEN + VLAN_HLEN) | IXGBE_RXDCTL_RLPML_EN);
+ }
+
if (hw->mac.type == ixgbe_mac_82598EB) {
/*
* enable cache line friendly hardware writes:
int max_frame = new_mtu + ETH_HLEN + ETH_FCS_LEN;
/* MTU < 68 is an error and causes problems on some kernels */
- if ((new_mtu < 68) || (max_frame > IXGBE_MAX_JUMBO_FRAME_SIZE))
- return -EINVAL;
+ if (adapter->flags & IXGBE_FLAG_SRIOV_ENABLED &&
+ hw->mac.type != ixgbe_mac_X540) {
+ if ((new_mtu < 68) || (max_frame > MAXIMUM_ETHERNET_VLAN_SIZE))
+ return -EINVAL;
+ } else {
+ if ((new_mtu < 68) || (max_frame > IXGBE_MAX_JUMBO_FRAME_SIZE))
+ return -EINVAL;
+ }
e_info(probe, "changing MTU from %d to %d\n", netdev->mtu, new_mtu);
/* must set new MTU before calling down or up */
return adapter->hw.mac.ops.set_vfta(&adapter->hw, vid, vf, (bool)add);
}
+void ixgbe_set_vf_lpe(struct ixgbe_adapter *adapter, u32 *msgbuf)
+{
+ struct ixgbe_hw *hw = &adapter->hw;
+ int new_mtu = msgbuf[1];
+ u32 max_frs;
+ int max_frame = new_mtu + ETH_HLEN + ETH_FCS_LEN;
+
+ /* Only X540 supports jumbo frames in IOV mode */
+ if (adapter->hw.mac.type != ixgbe_mac_X540)
+ return;
+
+ /* MTU < 68 is an error and causes problems on some kernels */
+ if ((new_mtu < 68) || (max_frame > IXGBE_MAX_JUMBO_FRAME_SIZE)) {
+ e_err(drv, "VF mtu %d out of range\n", new_mtu);
+ return;
+ }
+
+ max_frs = (IXGBE_READ_REG(hw, IXGBE_MAXFRS) &
+ IXGBE_MHADD_MFS_MASK) >> IXGBE_MHADD_MFS_SHIFT;
+ if (max_frs < new_mtu) {
+ max_frs = new_mtu << IXGBE_MHADD_MFS_SHIFT;
+ IXGBE_WRITE_REG(hw, IXGBE_MAXFRS, max_frs);
+ }
+
+ e_info(hw, "VF requests change max MTU to %d\n", new_mtu);
+}
+
static void ixgbe_set_vmolr(struct ixgbe_hw *hw, u32 vf, bool aupe)
{
u32 vmolr = IXGBE_READ_REG(hw, IXGBE_VMOLR(vf));
hash_list, vf);
break;
case IXGBE_VF_SET_LPE:
- WARN_ON((msgbuf[0] & 0xFFFF) == IXGBE_VF_SET_LPE);
+ ixgbe_set_vf_lpe(adapter, msgbuf);
break;
case IXGBE_VF_SET_VLAN:
add = (msgbuf[0] & IXGBE_VT_MSGINFO_MASK)
#define IXGBE_RXCTRL_DMBYPS 0x00000002 /* Descriptor Monitor Bypass */
#define IXGBE_RXDCTL_ENABLE 0x02000000 /* Enable specific Rx Queue */
#define IXGBE_RXDCTL_VME 0x40000000 /* VLAN mode enable */
+#define IXGBE_RXDCTL_RLPMLMASK 0x00003FFF /* Only supported on the X540 */
+#define IXGBE_RXDCTL_RLPML_EN 0x00008000
#define IXGBE_FCTRL_SBP 0x00000002 /* Store Bad Packet */
#define IXGBE_FCTRL_MPE 0x00000100 /* Multicast Promiscuous Ena*/