struct iwl3945_rx_frame_stats *rx_stats = IWL_RX_STATS(pkt);
struct iwl3945_rx_frame_hdr *rx_hdr = IWL_RX_HDR(pkt);
struct iwl3945_rx_frame_end *rx_end = IWL_RX_END(pkt);
- int snr;
u16 rx_stats_sig_avg = le16_to_cpu(rx_stats->sig_avg);
u16 rx_stats_noise_diff = le16_to_cpu(rx_stats->noise_diff);
u8 network_packet;
/* Convert 3945's rssi indicator to dBm */
rx_status.signal = rx_stats->rssi - IWL39_RSSI_OFFSET;
- /* Set default noise value to -127 */
- if (priv->last_rx_noise == 0)
- priv->last_rx_noise = IWL_NOISE_MEAS_NOT_AVAILABLE;
-
- /* 3945 provides noise info for OFDM frames only.
- * sig_avg and noise_diff are measured by the 3945's digital signal
- * processor (DSP), and indicate linear levels of signal level and
- * distortion/noise within the packet preamble after
- * automatic gain control (AGC). sig_avg should stay fairly
- * constant if the radio's AGC is working well.
- * Since these values are linear (not dB or dBm), linear
- * signal-to-noise ratio (SNR) is (sig_avg / noise_diff).
- * Convert linear SNR to dB SNR, then subtract that from rssi dBm
- * to obtain noise level in dBm.
- * Calculate rx_status.signal (quality indicator in %) based on SNR. */
- if (rx_stats_noise_diff) {
- snr = rx_stats_sig_avg / rx_stats_noise_diff;
- rx_status.noise = rx_status.signal -
- iwl3945_calc_db_from_ratio(snr);
- } else {
- rx_status.noise = priv->last_rx_noise;
- }
-
-
- IWL_DEBUG_STATS(priv, "Rssi %d noise %d sig_avg %d noise_diff %d\n",
- rx_status.signal, rx_status.noise,
- rx_stats_sig_avg, rx_stats_noise_diff);
+ IWL_DEBUG_STATS(priv, "Rssi %d sig_avg %d noise_diff %d\n",
+ rx_status.signal, rx_stats_sig_avg,
+ rx_stats_noise_diff);
header = (struct ieee80211_hdr *)IWL_RX_DATA(pkt);
network_packet = iwl3945_is_network_packet(priv, header);
- IWL_DEBUG_STATS_LIMIT(priv, "[%c] %d RSSI:%d Signal:%u, Noise:%u, Rate:%u\n",
+ IWL_DEBUG_STATS_LIMIT(priv, "[%c] %d RSSI:%d Signal:%u, Rate:%u\n",
network_packet ? '*' : ' ',
le16_to_cpu(rx_hdr->channel),
rx_status.signal, rx_status.signal,
- rx_status.noise, rx_status.rate_idx);
+ rx_status.rate_idx);
/* Set "1" to report good data frames in groups of 100 */
iwl3945_dbg_report_frame(priv, pkt, header, 1);
le32_to_cpu(rx_end->beacon_timestamp);
priv->_3945.last_tsf = le64_to_cpu(rx_end->timestamp);
priv->_3945.last_rx_rssi = rx_status.signal;
- priv->last_rx_noise = rx_status.noise;
}
iwl3945_pass_packet_to_mac80211(priv, rxb, &rx_status);
/* Find max signal strength (dBm) among 3 antenna/receiver chains */
rx_status.signal = iwlagn_calc_rssi(priv, phy_res);
- /* Meaningful noise values are available only from beacon statistics,
- * which are gathered only when associated, and indicate noise
- * only for the associated network channel ...
- * Ignore these noise values while scanning (other channels) */
- if (iwl_is_associated(priv) &&
- !test_bit(STATUS_SCANNING, &priv->status)) {
- rx_status.noise = priv->last_rx_noise;
- } else {
- rx_status.noise = IWL_NOISE_MEAS_NOT_AVAILABLE;
- }
-
- /* Reset beacon noise level if not associated. */
- if (!iwl_is_associated(priv))
- priv->last_rx_noise = IWL_NOISE_MEAS_NOT_AVAILABLE;
-
#ifdef CONFIG_IWLWIFI_DEBUG
/* Set "1" to report good data frames in groups of 100 */
if (unlikely(iwl_get_debug_level(priv) & IWL_DL_RX))
iwlagn_dbg_report_frame(priv, phy_res, len, header, 1);
#endif
iwl_dbg_log_rx_data_frame(priv, len, header);
- IWL_DEBUG_STATS_LIMIT(priv, "Rssi %d, noise %d, TSF %llu\n",
- rx_status.signal, rx_status.noise,
- (unsigned long long)rx_status.mactime);
+ IWL_DEBUG_STATS_LIMIT(priv, "Rssi %d, TSF %llu\n",
+ rx_status.signal, (unsigned long long)rx_status.mactime);
/*
* "antenna number"
le32_to_cpu(rx_info->beacon_silence_rssi_b) & IN_BAND_FILTER;
int bcn_silence_c =
le32_to_cpu(rx_info->beacon_silence_rssi_c) & IN_BAND_FILTER;
+ int last_rx_noise;
if (bcn_silence_a) {
total_silence += bcn_silence_a;
/* Average among active antennas */
if (num_active_rx)
- priv->last_rx_noise = (total_silence / num_active_rx) - 107;
+ last_rx_noise = (total_silence / num_active_rx) - 107;
else
- priv->last_rx_noise = IWL_NOISE_MEAS_NOT_AVAILABLE;
+ last_rx_noise = IWL_NOISE_MEAS_NOT_AVAILABLE;
IWL_DEBUG_CALIB(priv, "inband silence a %u, b %u, c %u, dBm %d\n",
bcn_silence_a, bcn_silence_b, bcn_silence_c,
- priv->last_rx_noise);
+ last_rx_noise);
}
#ifdef CONFIG_IWLWIFI_DEBUG