ath10k: fix pmf for wmi-tlv on qca6174

New wmi-tlv firmware uses HTT 3.0 protocol which
uses TX_FRM command for management frames (instead
of a dedicated command). To support PMF it is
necessary to provide explicit tailroom.

Signed-off-by: Marek Kwaczynski <marek.kwaczynski@tieto.com>
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

diff --git a/drivers/net/wireless/ath/ath10k/htt_tx.c b/drivers/net/wireless/ath/ath10k/htt_tx.c
index 2a8667e95c46605f776088e1d01afde220f2351d..c1961e77d58d839ac926e6b5282c13014cc7025f 100644 (file)
--- a/drivers/net/wireless/ath/ath10k/htt_tx.c
+++ b/drivers/net/wireless/ath/ath10k/htt_tx.c
@@ -454,6 +454,12 @@ int ath10k_htt_tx(struct ath10k_htt *htt, struct sk_buff *msdu)
        }
        skb_cb->htt.txbuf_paddr = paddr;
 
+       if ((ieee80211_is_action(hdr->frame_control) ||
+            ieee80211_is_deauth(hdr->frame_control) ||
+            ieee80211_is_disassoc(hdr->frame_control)) &&
+            ieee80211_has_protected(hdr->frame_control))
+               skb_put(msdu, IEEE80211_CCMP_MIC_LEN);
+
        skb_cb->paddr = dma_map_single(dev, msdu->data, msdu->len,
                                       DMA_TO_DEVICE);
        res = dma_mapping_error(dev, skb_cb->paddr);