From: Catherine Sullivan Date: Wed, 26 Aug 2015 19:14:16 +0000 (-0400) Subject: i40e: Never let speed get set to 0 in get_settings X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=0002e1189b594d462c7a93417f5ac8bbc22bd768;p=linux-beck.git i40e: Never let speed get set to 0 in get_settings In ethtool, there is a possibility of speed getting set to 0 if advertise is set to 0 (which it is when autoneg is disabled). We never want this to happen as the firmware will actually attempt to set the speed to 0 sending link down, so add an extra check to make sure this doesn't happen. Change-ID: I62e0eeee2cbf043d8e6f5c9c9f0b92794e877f01 Signed-off-by: Catherine Sullivan Tested-by: Andrew Bowers Signed-off-by: Jeff Kirsher --- diff --git a/drivers/net/ethernet/intel/i40e/i40e_ethtool.c b/drivers/net/ethernet/intel/i40e/i40e_ethtool.c index 928bd5abbaed..930369c4882b 100644 --- a/drivers/net/ethernet/intel/i40e/i40e_ethtool.c +++ b/drivers/net/ethernet/intel/i40e/i40e_ethtool.c @@ -666,6 +666,13 @@ static int i40e_set_settings(struct net_device *netdev, advertise & ADVERTISED_40000baseLR4_Full) config.link_speed |= I40E_LINK_SPEED_40GB; + /* If speed didn't get set, set it to what it currently is. + * This is needed because if advertise is 0 (as it is when autoneg + * is disabled) then speed won't get set. + */ + if (!config.link_speed) + config.link_speed = abilities.link_speed; + if (change || (abilities.link_speed != config.link_speed)) { /* copy over the rest of the abilities */ config.phy_type = abilities.phy_type;