From: Krzysztof Wojcik Date: Fri, 4 Feb 2011 13:18:26 +0000 (+0100) Subject: FIX: md: process hangs at wait_barrier after 0->10 takeover X-Git-Tag: v2.6.38-rc5~55^2 X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=02214dc5461c36da26a34014cab4e1bb484edba2;p=karo-tx-linux.git FIX: md: process hangs at wait_barrier after 0->10 takeover Following symptoms were observed: 1. After raid0->raid10 takeover operation we have array with 2 missing disks. When we add disk for rebuild, recovery process starts as expected but it does not finish- it stops at about 90%, md126_resync process hangs in "D" state. 2. Similar behavior is when we have mounted raid0 array and we execute takeover to raid10. After this when we try to unmount array- it causes process umount hangs in "D" In scenarios above processes hang at the same function- wait_barrier in raid10.c. Process waits in macro "wait_event_lock_irq" until the "!conf->barrier" condition will be true. In scenarios above it never happens. Reason was that at the end of level_store, after calling pers->run, we call mddev_resume. This calls pers->quiesce(mddev, 0) with RAID10, that calls lower_barrier. However raise_barrier hadn't been called on that 'conf' yet, so conf->barrier becomes negative, which is bad. This patch introduces setting conf->barrier=1 after takeover operation. It prevents to become barrier negative after call lower_barrier(). Signed-off-by: Krzysztof Wojcik Signed-off-by: NeilBrown --- diff --git a/drivers/md/raid10.c b/drivers/md/raid10.c index 69b659544390..3b607b28741b 100644 --- a/drivers/md/raid10.c +++ b/drivers/md/raid10.c @@ -2463,11 +2463,13 @@ static void *raid10_takeover_raid0(mddev_t *mddev) mddev->recovery_cp = MaxSector; conf = setup_conf(mddev); - if (!IS_ERR(conf)) + if (!IS_ERR(conf)) { list_for_each_entry(rdev, &mddev->disks, same_set) if (rdev->raid_disk >= 0) rdev->new_raid_disk = rdev->raid_disk * 2; - + conf->barrier = 1; + } + return conf; }