From: Michel Dänzer Date: Fri, 22 May 2009 10:59:10 +0000 (+0000) Subject: therm_adt746x: Always clear hardware bit which inverts fan speed range. X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=0512a9a8e277a9de2820211eef964473b714ae65;p=linux-beck.git therm_adt746x: Always clear hardware bit which inverts fan speed range. This bit would get enabled sometimes (probably after suspend/resume), so the fan would run at full speed below the temperature thresholds, but slow down and eventually stop if temperatures rose above the thresholds... not exactly what you want. Signed-off-by: Michel Dänzer Signed-off-by: Benjamin Herrenschmidt --- diff --git a/drivers/macintosh/therm_adt746x.c b/drivers/macintosh/therm_adt746x.c index c0621d50c8a0..0ddf9044948a 100644 --- a/drivers/macintosh/therm_adt746x.c +++ b/drivers/macintosh/therm_adt746x.c @@ -37,6 +37,7 @@ #define CONFIG_REG 0x40 #define MANUAL_MASK 0xe0 #define AUTO_MASK 0x20 +#define INVERT_MASK 0x10 static u8 TEMP_REG[3] = {0x26, 0x25, 0x27}; /* local, sensor1, sensor2 */ static u8 LIMIT_REG[3] = {0x6b, 0x6a, 0x6c}; /* local, sensor1, sensor2 */ @@ -229,7 +230,8 @@ static void write_fan_speed(struct thermostat *th, int speed, int fan) if (speed >= 0) { manual = read_reg(th, MANUAL_MODE[fan]); - write_reg(th, MANUAL_MODE[fan], manual|MANUAL_MASK); + write_reg(th, MANUAL_MODE[fan], + (manual|MANUAL_MASK) & (~INVERT_MASK)); write_reg(th, FAN_SPD_SET[fan], speed); } else { /* back to automatic */