From: Linus Walleij Date: Sun, 18 Dec 2016 21:55:55 +0000 (+0100) Subject: iio: light: add DT bindings for Capella CM3605 X-Git-Tag: v4.11-rc1~116^2~332^2~32 X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=170df593a4e4b2750fe1a141bda5174c66206f3e;p=karo-tx-linux.git iio: light: add DT bindings for Capella CM3605 This adds device tree bindings for the Capella Microsystems CM3605 ambient light sensor and short range proximity sensor. Cc: devicetree@vger.kernel.org Cc: Capella Microsystems Cc: Kevin Tsai Acked-by: Rob Herring Signed-off-by: Linus Walleij Signed-off-by: Jonathan Cameron --- diff --git a/Documentation/devicetree/bindings/iio/light/cm3605.txt b/Documentation/devicetree/bindings/iio/light/cm3605.txt new file mode 100644 index 000000000000..56331a79f9ab --- /dev/null +++ b/Documentation/devicetree/bindings/iio/light/cm3605.txt @@ -0,0 +1,41 @@ +Capella Microsystems CM3605 +Ambient Light and Short Distance Proximity Sensor + +The CM3605 is an entirely analog part which however require quite a bit of +software logic to interface a host operating system. + +This ALS and proximity sensor was one of the very first deployed in mobile +handsets, notably it is used in the very first Nexus One Android phone from +2010. + +Required properties: +- compatible: must be: "capella,cm3605" +- aset-gpios: GPIO line controlling the ASET line (drive low + to activate the ALS, should be flagged GPIO_ACTIVE_LOW) +- interrupts: the IRQ line (such as a GPIO) that is connected to + the POUT (proximity sensor out) line. The edge detection must + be set to IRQ_TYPE_EDGE_BOTH so as to detect movements toward + and away from the proximity sensor. +- io-channels: the ADC channel used for converting the voltage from + AOUT to a digital representation. +- io-channel-names: must be "aout" + +Optional properties: +- vdd-supply: regulator supplying VDD power to the component. +- capella,aset-resistance-ohms: the sensitivity calibration resistance, + in Ohms. Valid values are: 50000, 100000, 300000 and 600000, + as these are the resistance values that we are supplied with + calibration curves for. If not supplied, 100 kOhm will be assumed + but it is strongly recommended to supply this. + +Example: + +cm3605 { + compatible = "capella,cm3605"; + vdd-supply = <&foo_reg>; + aset-gpios = <&foo_gpio 1 GPIO_ACTIVE_LOW>; + capella,aset-resistance-ohms = <100000>; + interrupts = <1 IRQ_TYPE_EDGE_BOTH>; + io-channels = <&adc 0x01>; + io-channel-names = "aout"; +};