From: Richard Zhao Date: Tue, 15 May 2012 07:34:40 +0000 (+0800) Subject: ARM: i.MX: change timer clock from ipg to perclk X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=1f152b48eaaf4918047e84777b01a6d687f066e9;p=linux-beck.git ARM: i.MX: change timer clock from ipg to perclk Contrary to the ipg clock the perclk rate is not changed or gated in low power mode, so we choose perclk for gpt. With the port to the common clock framework as a side effect the timer used the rate returned from the peripheral clock but the hardware was still programmed to use the ipg clock, so this patch only changes the hardware to really use the clock it already assumed. Signed-off-by: Richard Zhao Signed-off-by: Sascha Hauer --- diff --git a/arch/arm/plat-mxc/time.c b/arch/arm/plat-mxc/time.c index 99f958ca6cb8..d865f7960baf 100644 --- a/arch/arm/plat-mxc/time.c +++ b/arch/arm/plat-mxc/time.c @@ -58,6 +58,7 @@ /* MX31, MX35, MX25, MX5 */ #define V2_TCTL_WAITEN (1 << 3) /* Wait enable mode */ #define V2_TCTL_CLK_IPG (1 << 6) +#define V2_TCTL_CLK_PER (2 << 6) #define V2_TCTL_FRR (1 << 9) #define V2_IR 0x0c #define V2_TSTAT 0x08 @@ -309,7 +310,7 @@ void __init mxc_timer_init(struct clk *timer_clk, void __iomem *base, int irq) __raw_writel(0, timer_base + MXC_TPRER); /* see datasheet note */ if (timer_is_v2()) - tctl_val = V2_TCTL_CLK_IPG | V2_TCTL_FRR | V2_TCTL_WAITEN | MXC_TCTL_TEN; + tctl_val = V2_TCTL_CLK_PER | V2_TCTL_FRR | V2_TCTL_WAITEN | MXC_TCTL_TEN; else tctl_val = MX1_2_TCTL_FRR | MX1_2_TCTL_CLK_PCLK1 | MXC_TCTL_TEN;