From: Tvrtko Ursulin Date: Thu, 11 Feb 2016 10:27:31 +0000 (+0000) Subject: drm/i915/guc: Do not wait for firmware load atomically X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=36894e8bc4d3eda9943a1df7d7efece808cd90a4;p=linux-beck.git drm/i915/guc: Do not wait for firmware load atomically It does not look like this code needs to wait atomically? Higher in the call chain it calls the GEM API and I do not see that the section is under any spin locks or such. Signed-off-by: Tvrtko Ursulin Cc: Alex Dai Reviewed-by: Dave Gordon --- diff --git a/drivers/gpu/drm/i915/intel_guc_loader.c b/drivers/gpu/drm/i915/intel_guc_loader.c index 3accd914490f..82a3c03fbc0e 100644 --- a/drivers/gpu/drm/i915/intel_guc_loader.c +++ b/drivers/gpu/drm/i915/intel_guc_loader.c @@ -199,7 +199,7 @@ static void set_guc_init_params(struct drm_i915_private *dev_priv) * the value matches either of two values representing completion * of the GuC boot process. * - * This is used for polling the GuC status in a wait_for_atomic() + * This is used for polling the GuC status in a wait_for() * loop below. */ static inline bool guc_ucode_response(struct drm_i915_private *dev_priv, @@ -259,14 +259,14 @@ static int guc_ucode_xfer_dma(struct drm_i915_private *dev_priv) I915_WRITE(DMA_CTRL, _MASKED_BIT_ENABLE(UOS_MOVE | START_DMA)); /* - * Spin-wait for the DMA to complete & the GuC to start up. + * Wait for the DMA to complete & the GuC to start up. * NB: Docs recommend not using the interrupt for completion. * Measurements indicate this should take no more than 20ms, so a * timeout here indicates that the GuC has failed and is unusable. * (Higher levels of the driver will attempt to fall back to * execlist mode if this happens.) */ - ret = wait_for_atomic(guc_ucode_response(dev_priv, &status), 100); + ret = wait_for(guc_ucode_response(dev_priv, &status), 100); DRM_DEBUG_DRIVER("DMA status 0x%x, GuC status 0x%x\n", I915_READ(DMA_CTRL), status);