From: Eliad Peller Date: Tue, 27 Nov 2012 06:44:46 +0000 (+0200) Subject: wlcore: allow ACX_BA_SESSION_RX_SETUP to fail X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=3b44b3b3687534be24171db6ff80669b3a6dcbab;p=linux-beck.git wlcore: allow ACX_BA_SESSION_RX_SETUP to fail Under some circumstances, that fw might be asked to remove a rx ba sessions it doesn't know about. In this case, instead of triggering a recovery, accept the error code (CMD_STATUS_NO_RX_BA_SESSION) and ignore it. [Arik - indicate failure up when the BA session cannot be setup] Signed-off-by: Eliad Peller Signed-off-by: Arik Nemtsov Signed-off-by: Luciano Coelho --- diff --git a/drivers/net/wireless/ti/wlcore/acx.c b/drivers/net/wireless/ti/wlcore/acx.c index ce108a736bd0..9c32f0c840d7 100644 --- a/drivers/net/wireless/ti/wlcore/acx.c +++ b/drivers/net/wireless/ti/wlcore/acx.c @@ -1433,13 +1433,22 @@ int wl12xx_acx_set_ba_receiver_session(struct wl1271 *wl, u8 tid_index, acx->win_size = wl->conf.ht.rx_ba_win_size; acx->ssn = ssn; - ret = wl1271_cmd_configure(wl, ACX_BA_SESSION_RX_SETUP, acx, - sizeof(*acx)); + ret = wlcore_cmd_configure_failsafe(wl, ACX_BA_SESSION_RX_SETUP, acx, + sizeof(*acx), + BIT(CMD_STATUS_NO_RX_BA_SESSION)); if (ret < 0) { wl1271_warning("acx ba receiver session failed: %d", ret); goto out; } + /* sometimes we can't start the session */ + if (ret == CMD_STATUS_NO_RX_BA_SESSION) { + wl1271_warning("no fw rx ba on tid %d", tid_index); + ret = -EBUSY; + goto out; + } + + ret = 0; out: kfree(acx); return ret;