From: Mauro Carvalho Chehab Date: Mon, 25 Jan 2016 16:39:34 +0000 (-0200) Subject: [media] tvp5150: Fix breakage for serial usage X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=47de9bf8931e;p=linux-beck.git [media] tvp5150: Fix breakage for serial usage changeset 460b6c0831cb ("tvp5150: Add s_stream subdev operation support") broke for em28xx-based devices with uses tvp5150. On those devices, touching the TVP5150_MISC_CTL register causes em28xx to stop streaming. I suspect that it uses the 27 MHz clock provided by tvp5150 to feed em28xx. So, change the logic to do nothing on s_stream if the tvp5150 is not set up to work with V4L2_MBUS_PARALLEL. Tested with Hauppauge WinTV USB 2 model 42012 Rev. C186 (USB ID: 2040:4200). Cc: Javier Martinez Canillas Cc: Laurent Pinchart Signed-off-by: Mauro Carvalho Chehab --- diff --git a/drivers/media/i2c/tvp5150.c b/drivers/media/i2c/tvp5150.c index 437f1a7ecb96..779c6f453cc9 100644 --- a/drivers/media/i2c/tvp5150.c +++ b/drivers/media/i2c/tvp5150.c @@ -975,19 +975,18 @@ static int tvp5150_g_mbus_config(struct v4l2_subdev *sd, static int tvp5150_s_stream(struct v4l2_subdev *sd, int enable) { struct tvp5150 *decoder = to_tvp5150(sd); - /* Output format: 8-bit ITU-R BT.656 with embedded syncs */ - int val = 0x09; /* Output format: 8-bit 4:2:2 YUV with discrete sync */ - if (decoder->mbus_type == V4L2_MBUS_PARALLEL) - val = 0x0d; + if (decoder->mbus_type != V4L2_MBUS_PARALLEL) + return 0; /* Initializes TVP5150 to its default values */ /* # set PCLK (27MHz) */ tvp5150_write(sd, TVP5150_CONF_SHARED_PIN, 0x00); + /* Output format: 8-bit ITU-R BT.656 with embedded syncs */ if (enable) - tvp5150_write(sd, TVP5150_MISC_CTL, val); + tvp5150_write(sd, TVP5150_MISC_CTL, 0x09); else tvp5150_write(sd, TVP5150_MISC_CTL, 0x00);