From: Robert Elliott Date: Fri, 14 Nov 2014 23:27:24 +0000 (-0600) Subject: hpsa: always call pci_set_master after pci_enable_device X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=4fa604e13bb2a6ef6e89224c80d96af385f533c3;p=linux-beck.git hpsa: always call pci_set_master after pci_enable_device If the kernel is booted with the reset_device parameter, which is done for kdump, then the driver needs to call pci_set_master after pci_enable_device to reenable bus mastering (since the preceding pci_disable_device call disables bus mastering). Also, place that after pci_request_regions both in the kdump code and the normal pci_init code. Remove the comment summarizing what pci_set_master does, with the incomplete commentary on the impact of pci_disable_device. Signed-off-by: Robert Elliott Signed-off-by: Don Brace Reviewed-by: Don Brace Signed-off-by: Christoph Hellwig --- diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c index 4db9d1921dca..36db63f63143 100644 --- a/drivers/scsi/hpsa.c +++ b/drivers/scsi/hpsa.c @@ -6363,15 +6363,15 @@ static int hpsa_pci_init(struct ctlr_info *h) return err; } - /* Enable bus mastering (pci_disable_device may disable this) */ - pci_set_master(h->pdev); - err = pci_request_regions(h->pdev, HPSA); if (err) { dev_err(&h->pdev->dev, "cannot obtain PCI resources, aborting\n"); return err; } + + pci_set_master(h->pdev); + hpsa_interrupt_mode(h); err = hpsa_pci_find_memory_BAR(h->pdev, &h->paddr); if (err) @@ -6451,7 +6451,9 @@ static int hpsa_init_reset_devices(struct pci_dev *pdev) dev_warn(&pdev->dev, "failed to enable device.\n"); return -ENODEV; } + pci_set_master(pdev); + /* Reset the controller with a PCI power-cycle or via doorbell */ rc = hpsa_kdump_hard_reset_controller(pdev);