From: Florian Vaussard Date: Wed, 30 Nov 2016 01:39:25 +0000 (-0800) Subject: Input: drv2667 - fix misuse of regmap_update_bits X-Git-Tag: v4.10-rc1~60^2^2~11 X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=6473bbfd7e85a9f834ed668b4daa31638c73ff53;p=karo-tx-linux.git Input: drv2667 - fix misuse of regmap_update_bits Using regmap_update_bits(..., mask, 1) with 'mask' following (1 << k) and k greater than 0 is wrong. Indeed, _regmap_update_bits will perform (mask & 1), which results in 0 if LSB of mask is 0. Thus the call regmap_update_bits(..., mask, 1) is in reality equivalent to regmap_update_bits(..., mask, 0). In such a case, the correct use is regmap_update_bits(..., mask, mask). This driver is performing such a mistake with the DRV2667_STANDBY mask, which equals (1 << 6). Fix the driver to make it consistent with the API, and fix the alignment problem at the same time. Please note that this change is untested, as I do not have this piece of hardware. Testers are welcome! Signed-off-by: Florian Vaussard Signed-off-by: Dmitry Torokhov --- diff --git a/drivers/input/misc/drv2667.c b/drivers/input/misc/drv2667.c index d5ba7481328c..2849bb6906a8 100644 --- a/drivers/input/misc/drv2667.c +++ b/drivers/input/misc/drv2667.c @@ -256,7 +256,7 @@ static void drv2667_close(struct input_dev *input) cancel_work_sync(&haptics->work); error = regmap_update_bits(haptics->regmap, DRV2667_CTRL_2, - DRV2667_STANDBY, 1); + DRV2667_STANDBY, DRV2667_STANDBY); if (error) dev_err(&haptics->client->dev, "Failed to enter standby mode: %d\n", error); @@ -415,7 +415,7 @@ static int __maybe_unused drv2667_suspend(struct device *dev) if (haptics->input_dev->users) { ret = regmap_update_bits(haptics->regmap, DRV2667_CTRL_2, - DRV2667_STANDBY, 1); + DRV2667_STANDBY, DRV2667_STANDBY); if (ret) { dev_err(dev, "Failed to set standby mode\n"); regulator_disable(haptics->regulator);