From: Stefan Wahren Date: Sat, 18 Jul 2015 12:30:42 +0000 (+0000) Subject: iio: mxs-lradc: fix some spelling errors X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=66926d11f326355abbd4e290047a67f17731b404;p=linux-beck.git iio: mxs-lradc: fix some spelling errors This patch fix some spelling errors in the comments. Signed-off-by: Stefan Wahren Reviewed-by: Marek Vasut Signed-off-by: Jonathan Cameron --- diff --git a/drivers/staging/iio/adc/mxs-lradc.c b/drivers/staging/iio/adc/mxs-lradc.c index 1ccb3676f2e5..386a44da7248 100644 --- a/drivers/staging/iio/adc/mxs-lradc.c +++ b/drivers/staging/iio/adc/mxs-lradc.c @@ -65,14 +65,14 @@ * Once the pen touches the touchscreen, the touchscreen switches from * IRQ-driven mode to polling mode to prevent interrupt storm. The polling * is realized by worker thread, which is called every 20 or so milliseconds. - * This gives the touchscreen enough fluence and does not strain the system + * This gives the touchscreen enough fluency and does not strain the system * too much. */ #define LRADC_TS_SAMPLE_DELAY_MS 5 /* * The LRADC reads the following amount of samples from each touchscreen - * channel and the driver then computes avarage of these. + * channel and the driver then computes average of these. */ #define LRADC_TS_SAMPLE_AMOUNT 4 @@ -238,7 +238,7 @@ struct mxs_lradc { * CH5 -- Touch screen YNLR * CH6 -- Touch screen WIPER (5-wire only) * - * The bitfields below represents which parts of the LRADC block are + * The bit fields below represents which parts of the LRADC block are * switched into special mode of operation. These channels can not * be sampled as regular LRADC channels. The driver will refuse any * attempt to sample these channels. @@ -252,7 +252,7 @@ struct mxs_lradc { struct input_dev *ts_input; enum mxs_lradc_id soc; - enum lradc_ts_plate cur_plate; /* statemachine */ + enum lradc_ts_plate cur_plate; /* state machine */ bool ts_valid; unsigned ts_x_pos; unsigned ts_y_pos; @@ -812,7 +812,7 @@ static int mxs_lradc_read_single(struct iio_dev *iio_dev, int chan, int *val) int ret; /* - * See if there is no buffered operation in progess. If there is, simply + * See if there is no buffered operation in progress. If there is, simply * bail out. This can be improved to support both buffered and raw IO at * the same time, yet the code becomes horribly complicated. Therefore I * applied KISS principle here.