From: Venkat Reddy Talla <vreddytalla@nvidia.com>
Date: Wed, 12 Apr 2017 10:15:04 +0000 (+0530)
Subject: regulator: tps65132: add device-tree binding
X-Git-Tag: v4.12-rc1~111^2~1^5~2
X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=682d33c65c28bca28238e84dc3f3b629008d1079;p=karo-tx-linux.git

regulator: tps65132: add device-tree binding

Add tps65132 regulator device-tree binding documentation

Signed-off-by: Venkat Reddy Talla <vreddytalla@nvidia.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
---

diff --git a/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt b/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
new file mode 100644
index 000000000000..3a3505520c69
--- /dev/null
+++ b/Documentation/devicetree/bindings/regulator/tps65132-regulator.txt
@@ -0,0 +1,46 @@
+TPS65132 regulators
+
+Required properties:
+- compatible: "ti,tps65132"
+- reg: I2C slave address
+
+Optional Subnode:
+Device supports two regulators OUTP and OUTN. A sub node within the
+   device node describe the properties of these regulators. The sub-node
+   names must be as follows:
+	-For regulator outp, the sub node name should be "outp".
+	-For regulator outn, the sub node name should be "outn".
+
+-enable-gpios:(active high, output) Regulators are controlled by the input pins.
+   If it is connected to GPIO through host system then provide the
+   gpio number as per gpio.txt.
+-active-discharge-gpios: (active high, output) Some configurations use delay mechanisms
+  on the enable pin, to keep the regulator enabled for some time after
+  the enable signal goes low. This GPIO is used to actively discharge
+  the delay mechanism. Requires specification of ti,active-discharge-time-us
+-ti,active-discharge-time-us: how long the active discharge gpio should be
+  asserted for during active discharge, in microseconds.
+
+Each regulator is defined using the standard binding for regulators.
+
+Example:
+
+	tps65132@3e {
+		compatible = "ti,tps65132";
+		reg = <0x3e>;
+
+		outp {
+			regulator-name = "outp";
+			regulator-boot-on;
+			regulator-always-on;
+			enable-gpios = <&gpio 23 0>;
+		};
+
+		outn {
+			regulator-name = "outn";
+			regulator-boot-on;
+			regulator-always-on;
+			regulator-active-discharge = <0>;
+			enable-gpios = <&gpio 40 0>;
+		};
+	};