From: Chunqiu Wang Date: Wed, 24 Jun 2009 17:13:39 +0000 (+0000) Subject: OMAP3: GPIO: Only enable WAKEUPEN for edge detection GPIOs X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=699117a69f53efbdf8fddbd6d991575c0a22fd74;p=linux-beck.git OMAP3: GPIO: Only enable WAKEUPEN for edge detection GPIOs According to the GPIO 'Wakeup and Interrupt' section of the TRM[1], wake-up requests can only be generated on edge transitions. Also for OMAP3, only edge GPIOs may lose interrupts when PER enters RET/OFF state, this is addressed by gpio prepare|resume idle functions [1] Section 25.5.3.1 OMAP34xx_ES3.1_TRM_V_Q Signed-off-by: Chunqiu Wang Signed-off-by: Kevin Hilman --- diff --git a/arch/arm/plat-omap/gpio.c b/arch/arm/plat-omap/gpio.c index 6216f4f09e82..2f185ffaca4a 100644 --- a/arch/arm/plat-omap/gpio.c +++ b/arch/arm/plat-omap/gpio.c @@ -724,7 +724,11 @@ static inline void set_24xx_gpio_triggering(struct gpio_bank *bank, int gpio, OMAP4_GPIO_IRQWAKEN0); } } else { - if (trigger != 0) + /* + * GPIO wakeup request can only be generated on edge + * transitions + */ + if (trigger & IRQ_TYPE_EDGE_BOTH) __raw_writel(1 << gpio, bank->base + OMAP24XX_GPIO_SETWKUENA); else @@ -734,7 +738,13 @@ static inline void set_24xx_gpio_triggering(struct gpio_bank *bank, int gpio, } /* This part needs to be executed always for OMAP34xx */ if (cpu_is_omap34xx() || (bank->non_wakeup_gpios & gpio_bit)) { - if (trigger != 0) + /* + * Log the edge gpio and manually trigger the IRQ + * after resume if the input level changes + * to avoid irq lost during PER RET/OFF mode + * Applies for omap2 non-wakeup gpio and all omap3 gpios + */ + if (trigger & IRQ_TYPE_EDGE_BOTH) bank->enabled_non_wakeup_gpios |= gpio_bit; else bank->enabled_non_wakeup_gpios &= ~gpio_bit;