From: Ludovic Desroches Date: Fri, 13 May 2016 13:16:02 +0000 (+0200) Subject: mmc: sdhci: fix wakeup configuration X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=84d62605290f3eecfc8df7b2f259b39487d6e392;p=linux-beck.git mmc: sdhci: fix wakeup configuration Activating wakeup event is not enough to get a wakeup signal. The corresponding events have to be enabled in the Interrupt Status Enable Register too. It follows the specification and is needed at least by sdhci-of-at91. Signed-off-by: Ludovic Desroches Acked-by: Adrian Hunter Signed-off-by: Ulf Hansson --- diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c index 88d75bb711df..040af1b6b412 100644 --- a/drivers/mmc/host/sdhci.c +++ b/drivers/mmc/host/sdhci.c @@ -2605,18 +2605,31 @@ static irqreturn_t sdhci_thread_irq(int irq, void *dev_id) \*****************************************************************************/ #ifdef CONFIG_PM +/* + * To enable wakeup events, the corresponding events have to be enabled in + * the Interrupt Status Enable register too. See 'Table 1-6: Wakeup Signal + * Table' in the SD Host Controller Standard Specification. + * It is useless to restore SDHCI_INT_ENABLE state in + * sdhci_disable_irq_wakeups() since it will be set by + * sdhci_enable_card_detection() or sdhci_init(). + */ void sdhci_enable_irq_wakeups(struct sdhci_host *host) { u8 val; u8 mask = SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE | SDHCI_WAKE_ON_INT; + u32 irq_val = SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE | + SDHCI_INT_CARD_INT; val = sdhci_readb(host, SDHCI_WAKE_UP_CONTROL); val |= mask ; /* Avoid fake wake up */ - if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) + if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) { val &= ~(SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE); + irq_val &= ~(SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE); + } sdhci_writeb(host, val, SDHCI_WAKE_UP_CONTROL); + sdhci_writel(host, irq_val, SDHCI_INT_ENABLE); } EXPORT_SYMBOL_GPL(sdhci_enable_irq_wakeups);