From: Stefan Agner Date: Fri, 13 Mar 2015 13:51:51 +0000 (+0100) Subject: tty: serial: fsl_lpuart: clear receive flag on FIFO flush X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=8e4934c6d6c6;p=linux-beck.git tty: serial: fsl_lpuart: clear receive flag on FIFO flush When the receiver was enabled during startup, a character could have been in the FIFO when the UART get initially used. The driver configures the (receive) watermark level, and flushes the FIFO. However, the receive flag (RDRF) could still be set at that stage (as mentioned in the register description of UARTx_RWFIFO). This leads to an interrupt which won't be handled properly in interrupt mode: The receive interrupt function lpuart_rxint checks the FIFO count, which is 0 at that point (due to the flush during initialization). The problem does not manifest when using DMA to receive characters. Fix this situation by explicitly read the status register, which leads to clearing of the RDRF flag. Due to the flush just after the status flag read, a explicit data read is not to required. Signed-off-by: Stefan Agner Cc: stable Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c index 7ec911000ec2..3ad1458bfeb0 100644 --- a/drivers/tty/serial/fsl_lpuart.c +++ b/drivers/tty/serial/fsl_lpuart.c @@ -921,6 +921,9 @@ static void lpuart_setup_watermark(struct lpuart_port *sport) writeb(val | UARTPFIFO_TXFE | UARTPFIFO_RXFE, sport->port.membase + UARTPFIFO); + /* explicitly clear RDRF */ + readb(sport->port.membase + UARTSR1); + /* flush Tx and Rx FIFO */ writeb(UARTCFIFO_TXFLUSH | UARTCFIFO_RXFLUSH, sport->port.membase + UARTCFIFO);