From: Sascha Silbe Date: Thu, 6 Feb 2014 22:24:13 +0000 (+0100) Subject: ARM: dts: imx6qdl-wandboard: use GPIO_6 for FEC interrupt X-Git-Tag: next-20140306~107^2~6^2~7 X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=9fc77821b17155c6e0ab50b1e1dd80c2b0e63e98;p=karo-tx-linux.git ARM: dts: imx6qdl-wandboard: use GPIO_6 for FEC interrupt Apply the same work-around for i.MX 6D/Q erratum 006687 as used for Sabre Lite for the Wandboard Dual / Quad. Like on the Sabre Lite, GPIO6 is used as a power down output for camera expansion boards. However, these expansion boards do not work with mainline yet anyway. Tested on a Wandboard Quad. Before the patch: root@arm:~# ping -q -f -c 10000 192.168.2.1 PING 192.168.2.1 (192.168.2.1) 56(84) bytes of data. === 192.168.2.1 ping statistics === 10000 packets transmitted, 10000 received, 0% packet loss, time 97363ms rtt min/avg/max/mdev = 0.290/9.586/10.198/1.432 ms, pipe 2, ipg/ewma 9.737/9.672 ms After the patch: root@arm:~# ping -q -f -c 10000 192.168.2.1 PING 192.168.2.1 (192.168.2.1) 56(84) bytes of data. === 192.168.2.1 ping statistics === 10000 packets transmitted, 10000 received, 0% packet loss, time 4810ms rtt min/avg/max/mdev = 0.246/0.355/0.863/0.044 ms, ipg/ewma 0.481/0.319 ms Signed-off-by: Sascha Silbe Signed-off-by: Shawn Guo --- diff --git a/arch/arm/boot/dts/imx6qdl-wandboard.dtsi b/arch/arm/boot/dts/imx6qdl-wandboard.dtsi index 81138b70c863..bdfdf89d405f 100644 --- a/arch/arm/boot/dts/imx6qdl-wandboard.dtsi +++ b/arch/arm/boot/dts/imx6qdl-wandboard.dtsi @@ -123,6 +123,7 @@ MX6QDL_PAD_RGMII_RD3__RGMII_RD3 0x1b0b0 MX6QDL_PAD_RGMII_RX_CTL__RGMII_RX_CTL 0x1b0b0 MX6QDL_PAD_GPIO_16__ENET_REF_CLK 0x4001b0a8 + MX6QDL_PAD_GPIO_6__ENET_IRQ 0x000b1 >; }; @@ -201,6 +202,8 @@ pinctrl-0 = <&pinctrl_enet>; phy-mode = "rgmii"; phy-reset-gpios = <&gpio3 29 0>; + interrupts-extended = <&gpio1 6 IRQ_TYPE_LEVEL_HIGH>, + <&intc 0 119 IRQ_TYPE_LEVEL_HIGH>; status = "okay"; };