From: Vasanthakumar Thiagarajan Date: Thu, 29 Dec 2011 10:35:38 +0000 (+0530) Subject: ath6kl: Add a module parameter to enable uart debug X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=a10e2f2f6db8f86eaca1cf3d00269463da4d6434;p=linux-beck.git ath6kl: Add a module parameter to enable uart debug To enable firmware debug messages through uart interface, modprobe ath6kl_sdio uart_debug=1. Signed-off-by: Vasanthakumar Thiagarajan Signed-off-by: Kalle Valo --- diff --git a/drivers/net/wireless/ath/ath6kl/init.c b/drivers/net/wireless/ath/ath6kl/init.c index e74279372ef8..a481b6a1715d 100644 --- a/drivers/net/wireless/ath/ath6kl/init.c +++ b/drivers/net/wireless/ath/ath6kl/init.c @@ -28,10 +28,12 @@ unsigned int debug_mask; static unsigned int testmode; static bool suspend_cutpower; +static unsigned int uart_debug; module_param(debug_mask, uint, 0644); module_param(testmode, uint, 0644); module_param(suspend_cutpower, bool, 0444); +module_param(uart_debug, uint, 0644); static const struct ath6kl_hw hw_list[] = { { @@ -464,6 +466,13 @@ int ath6kl_configure_target(struct ath6kl *ar) u8 fw_iftype, fw_mode = 0, fw_submode = 0; int i, status; + param = uart_debug; + if (ath6kl_bmi_write(ar, ath6kl_get_hi_item_addr(ar, + HI_ITEM(hi_serial_enable)), (u8 *)¶m, 4)) { + ath6kl_err("bmi_write_memory for uart debug failed\n"); + return -EIO; + } + /* * Note: Even though the firmware interface type is * chosen as BSS_STA for all three interfaces, can