From: Peter Meerwald Date: Thu, 19 Jul 2012 11:21:04 +0000 (+0200) Subject: mtd: omap2: fix some typos in comments X-Git-Tag: next-20120904~60^2~47 X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=a4d0d31f75492e11e2b2f31d531e25051b4c90c0;p=karo-tx-linux.git mtd: omap2: fix some typos in comments Signed-off-by: Peter Meerwald Signed-off-by: Artem Bityutskiy --- diff --git a/drivers/mtd/nand/omap2.c b/drivers/mtd/nand/omap2.c index ac4fd756eda3..1ede9fb43430 100644 --- a/drivers/mtd/nand/omap2.c +++ b/drivers/mtd/nand/omap2.c @@ -347,7 +347,7 @@ static void omap_nand_dma_callback(void *data) } /* - * omap_nand_dma_transfer: configer and start dma transfer + * omap_nand_dma_transfer: configure and start dma transfer * @mtd: MTD device structure * @addr: virtual address in RAM of source/destination * @len: number of data bytes to be transferred @@ -463,7 +463,7 @@ static void omap_write_buf_dma_pref(struct mtd_info *mtd, } /* - * omap_nand_irq - GMPC irq handler + * omap_nand_irq - GPMC irq handler * @this_irq: gpmc irq number * @dev: omap_nand_info structure pointer is passed here */ @@ -1205,8 +1205,8 @@ static int __devinit omap_nand_probe(struct platform_device *pdev) /* * If RDY/BSY line is connected to OMAP then use the omap ready - * funcrtion and the generic nand_wait function which reads the status - * register after monitoring the RDY/BSY line.Otherwise use a standard + * function and the generic nand_wait function which reads the status + * register after monitoring the RDY/BSY line. Otherwise use a standard * chip delay which is slightly more than tR (AC Timing) of the NAND * device and read status register until you get a failure or success */ @@ -1287,7 +1287,7 @@ static int __devinit omap_nand_probe(struct platform_device *pdev) info->nand.verify_buf = omap_verify_buf; - /* selsect the ecc type */ + /* select the ecc type */ if (pdata->ecc_opt == OMAP_ECC_HAMMING_CODE_DEFAULT) info->nand.ecc.mode = NAND_ECC_SOFT; else if ((pdata->ecc_opt == OMAP_ECC_HAMMING_CODE_HW) ||