From: Heiner Kallweit Date: Thu, 27 Oct 2016 19:26:46 +0000 (+0200) Subject: spi: fsl-espi: simplify and inline function fsl_espi_change_mode X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=b3bec5f95f73520feb05b90244522f24546e96aa;p=linux-beck.git spi: fsl-espi: simplify and inline function fsl_espi_change_mode The ESPI spec mentions no requirement to turn off the ESPI unit prior to changing the mode. Most likely the ESPI unit is only turned off to clear the FIFO's as before this patch series single bytes could remain in the TX FIFO after transfer end. Therefore remove disabling / re-enabling the ESPI unit. Signed-off-by: Heiner Kallweit Signed-off-by: Mark Brown --- diff --git a/drivers/spi/spi-fsl-espi.c b/drivers/spi/spi-fsl-espi.c index 5a7449f3b3b8..d5506852e63c 100644 --- a/drivers/spi/spi-fsl-espi.c +++ b/drivers/spi/spi-fsl-espi.c @@ -223,26 +223,6 @@ static void fsl_espi_fill_tx_fifo(struct mpc8xxx_spi *mspi, u32 events) } } -static void fsl_espi_change_mode(struct spi_device *spi) -{ - struct mpc8xxx_spi *mspi = spi_master_get_devdata(spi->master); - struct spi_mpc8xxx_cs *cs = spi->controller_state; - u32 tmp; - unsigned long flags; - - /* Turn off IRQs locally to minimize time that SPI is disabled. */ - local_irq_save(flags); - - /* Turn off SPI unit prior changing mode */ - tmp = fsl_espi_read_reg(mspi, ESPI_SPMODE); - fsl_espi_write_reg(mspi, ESPI_SPMODE, tmp & ~SPMODE_ENABLE); - fsl_espi_write_reg(mspi, ESPI_SPMODEx(spi->chip_select), - cs->hw_mode); - fsl_espi_write_reg(mspi, ESPI_SPMODE, tmp); - - local_irq_restore(flags); -} - static void fsl_espi_setup_transfer(struct spi_device *spi, struct spi_transfer *t) { @@ -276,7 +256,8 @@ static void fsl_espi_setup_transfer(struct spi_device *spi, cs->hw_mode |= CSMODE_PM(pm); - fsl_espi_change_mode(spi); + fsl_espi_write_reg(mpc8xxx_spi, ESPI_SPMODEx(spi->chip_select), + cs->hw_mode); } static int fsl_espi_bufs(struct spi_device *spi, struct spi_transfer *t)