From: Raanan Avargil Date: Tue, 22 Dec 2015 13:35:04 +0000 (+0200) Subject: e1000e: Clear ULP configuration register on ULP exit X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=c5c6d07761a9ff64f0ffff2ca410a578fb7c4579;p=linux-beck.git e1000e: Clear ULP configuration register on ULP exit There have been bugs caused by HW ULP configuration settings not being properly cleared after cable connect in V-Pro capable systems. This caused HW to get out of sync occasionally. The fix ensures that ULP settings are cleared in HW after LAN cable re-connect. Signed-off-by: Raanan Avargil Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher --- diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.c b/drivers/net/ethernet/intel/e1000e/ich8lan.c index e7ccf5ffa835..c0f4887ea44d 100644 --- a/drivers/net/ethernet/intel/e1000e/ich8lan.c +++ b/drivers/net/ethernet/intel/e1000e/ich8lan.c @@ -1328,6 +1328,8 @@ static s32 e1000_disable_ulp_lpt_lp(struct e1000_hw *hw, bool force) I218_ULP_CONFIG1_RESET_TO_SMBUS | I218_ULP_CONFIG1_WOL_HOST | I218_ULP_CONFIG1_INBAND_EXIT | + I218_ULP_CONFIG1_EN_ULP_LANPHYPC | + I218_ULP_CONFIG1_DIS_CLR_STICKY_ON_PERST | I218_ULP_CONFIG1_DISABLE_SMB_PERST); e1000_write_phy_reg_hv_locked(hw, I218_ULP_CONFIG1, phy_reg); diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.h b/drivers/net/ethernet/intel/e1000e/ich8lan.h index 7d85f002c3d2..2311f6003f58 100644 --- a/drivers/net/ethernet/intel/e1000e/ich8lan.h +++ b/drivers/net/ethernet/intel/e1000e/ich8lan.h @@ -188,6 +188,10 @@ #define I218_ULP_CONFIG1_INBAND_EXIT 0x0020 /* Inband on ULP exit */ #define I218_ULP_CONFIG1_WOL_HOST 0x0040 /* WoL Host on ULP exit */ #define I218_ULP_CONFIG1_RESET_TO_SMBUS 0x0100 /* Reset to SMBus mode */ +/* enable ULP even if when phy powered down via lanphypc */ +#define I218_ULP_CONFIG1_EN_ULP_LANPHYPC 0x0400 +/* disable clear of sticky ULP on PERST */ +#define I218_ULP_CONFIG1_DIS_CLR_STICKY_ON_PERST 0x0800 #define I218_ULP_CONFIG1_DISABLE_SMB_PERST 0x1000 /* Disable on PERST# */ /* SMBus Address Phy Register */