From: Eric Bentley Date: Tue, 30 Aug 2016 06:16:19 +0000 (-0400) Subject: ath6kl: Allow the radio to report 0 dbm txpower without timing out X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=cabd34d0e9c47ac8747e7a1d871e10acdb8e980f;p=linux-beck.git ath6kl: Allow the radio to report 0 dbm txpower without timing out The ath6kl driver attempts to get the txpower value from the radio by first clearing the existing stored value and then watching the value to become non-zero. APs allow setting client power to values from -127..127, but this radio is not capable of setting values less then 0 and so will report txpower as 0dbm for both negative and 0 client power values. When the radio has txpower set to 0dbm txpower (equivalent to 1mw) the ath6kl_cfg80211_get_txpower() function will remain in the wait_event_interruptible_timeout() loop waiting for the value to be non-zero, and will eventually timeout. This results in a 5 second delay in response. However, the correct value of zero is eventually returned. The 6004 defaults to 63dbm which is then limited by regulatory and hardware limits with max of 18dbm (6003 max is 16dbm), therefore we can use values larger then these to be able to determine when the value has been updated. To correct the issue, set the value to a nonsensical value (255) and wait for it to change to the valid value. Tested on both 6003 and 6004 based radios. Return value of zero is correctly returned in an expected amount of time (similar to when returning non-zero values) when AP client power is set to both 0 and negative values. Signed-off-by: Eric Bentley Signed-off-by: Kalle Valo --- diff --git a/drivers/net/wireless/ath/ath6kl/cfg80211.c b/drivers/net/wireless/ath/ath6kl/cfg80211.c index 72e2ec67768d..b7fe0af4cb24 100644 --- a/drivers/net/wireless/ath/ath6kl/cfg80211.c +++ b/drivers/net/wireless/ath/ath6kl/cfg80211.c @@ -1449,14 +1449,14 @@ static int ath6kl_cfg80211_get_txpower(struct wiphy *wiphy, return -EIO; if (test_bit(CONNECTED, &vif->flags)) { - ar->tx_pwr = 0; + ar->tx_pwr = 255; if (ath6kl_wmi_get_tx_pwr_cmd(ar->wmi, vif->fw_vif_idx) != 0) { ath6kl_err("ath6kl_wmi_get_tx_pwr_cmd failed\n"); return -EIO; } - wait_event_interruptible_timeout(ar->event_wq, ar->tx_pwr != 0, + wait_event_interruptible_timeout(ar->event_wq, ar->tx_pwr != 255, 5 * HZ); if (signal_pending(current)) {