From: Michal Simek Date: Mon, 3 Jun 2013 12:31:18 +0000 (+0200) Subject: GPIO: xilinx: Use __raw_readl/__raw_writel IO functions X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=cc090d61d1a88f30f2fb75a91bce684ad1bd2e94;p=linux-beck.git GPIO: xilinx: Use __raw_readl/__raw_writel IO functions This driver can be used on Xilinx ARM Zynq platform where in_be32/out_be32 functions are not implemented. Use __raw_readl/__raw_writel functions which are implemented on Microblaze and PowerPC. For ARM readl/writel functions are used instead. The correct way how to implement this is to detect endians directly on IP. But for the gpio case without interrupt connected(it means without interrupt logic) there are just 2 registers data and tristate where auto detection can't be done. Signed-off-by: Michal Simek Signed-off-by: Linus Walleij --- diff --git a/drivers/gpio/gpio-xilinx.c b/drivers/gpio/gpio-xilinx.c index 626eaa876f09..791ddaedbfb4 100644 --- a/drivers/gpio/gpio-xilinx.c +++ b/drivers/gpio/gpio-xilinx.c @@ -30,8 +30,13 @@ #define XGPIO_CHANNEL_OFFSET 0x8 /* Read/Write access to the GPIO registers */ -#define xgpio_readreg(offset) in_be32(offset) -#define xgpio_writereg(offset, val) out_be32(offset, val) +#ifdef CONFIG_ARCH_ZYNQ +# define xgpio_readreg(offset) readl(offset) +# define xgpio_writereg(offset, val) writel(val, offset) +#else +# define xgpio_readreg(offset) __raw_readl(offset) +# define xgpio_writereg(offset, val) __raw_writel(val, offset) +#endif /** * struct xgpio_instance - Stores information about GPIO device