From: Jack Pham Date: Fri, 11 Dec 2015 00:28:56 +0000 (-0600) Subject: usb: host: ehci-msm: Fix register initialization X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=e8f55b91482247b0b11b2f2f12188d9be55bbd19;p=linux-beck.git usb: host: ehci-msm: Fix register initialization The default value for the 'transceiver select' field of the PORTSC register may not always be correct. Previously the phy-msm-usb driver would do this for us, but since ehci-msm can now be instantiated standalone without any PHY driver, the register needs to be explicitly initialized to ULPI mode to properly communicate with the PHY. This is not readily apparent, as firmware or bootloader code also happen to pre-initialize this for us. However, it can manifest when performing a driver unbind/rebind as follows: cd /sys/bus/platform/drivers/msm_hsusb_host echo QCOM8040:00 > unbind echo QCOM8040:00 > bind The EHCI core executes a controller reset as part of this, and as a result the register in question would revert to its default state and must be re-initialized properly. Furthermore this may be useful in the future when adding PM suspend/resume support. Signed-off-by: Jack Pham Signed-off-by: Timur Tabi Reviewed-by: Andy Gross Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/usb/host/ehci-msm.c b/drivers/usb/host/ehci-msm.c index 102837e58bbf..b71947d04fed 100644 --- a/drivers/usb/host/ehci-msm.c +++ b/drivers/usb/host/ehci-msm.c @@ -56,6 +56,8 @@ static int ehci_msm_reset(struct usb_hcd *hcd) if (retval) return retval; + /* select ULPI phy and clear other status/control bits in PORTSC */ + writel(PORTSC_PTS_ULPI, USB_PORTSC); /* bursts of unspecified length. */ writel(0, USB_AHBBURST); /* Use the AHB transactor, allow posted data writes */