From: Jonas Aaberg Date: Thu, 25 Oct 2012 06:40:42 +0000 (+0200) Subject: pinctrl/nomadik: make independent of prcmu driver X-Git-Tag: next-20121112~25^2~5^2~1 X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=f1671bf5f0721356f0c7bc1b2fec54b1aaf40418;p=karo-tx-linux.git pinctrl/nomadik: make independent of prcmu driver Currently there are some unnecessary criss-cross dependencies between the PRCMU driver in MFD and a lot of other drivers, mainly because other drivers need to poke around in the PRCM register range. In cases like this there are actually just a few select registers that the pinctrl driver need to read/modify/write, and it turns out that no other driver is actually using these registers, so there are no concurrency issues whatsoever. So: don't let the location of the register range complicate things, just poke into these registers directly and skip a layer of indirection. Take this opportunity to add kerneldoc to the pinctrl state container. Cc: Loic Pallardy Signed-off-by: Jonas Aaberg Signed-off-by: Linus Walleij --- diff --git a/drivers/pinctrl/pinctrl-nomadik.c b/drivers/pinctrl/pinctrl-nomadik.c index 22f69375bb3a..6a95d0438b6a 100644 --- a/drivers/pinctrl/pinctrl-nomadik.c +++ b/drivers/pinctrl/pinctrl-nomadik.c @@ -30,20 +30,6 @@ #include /* Since we request GPIOs from ourself */ #include -/* - * For the U8500 archs, use the PRCMU register interface, for the older - * Nomadik, provide some stubs. The functions using these will only be - * called on the U8500 series. - */ -#ifdef CONFIG_ARCH_U8500 -#include -#else -static inline u32 prcmu_read(unsigned int reg) { - return 0; -} -static inline void prcmu_write(unsigned int reg, u32 value) {} -static inline void prcmu_write_masked(unsigned int reg, u32 mask, u32 value) {} -#endif #include #include @@ -82,10 +68,18 @@ struct nmk_gpio_chip { u32 lowemi; }; +/** + * struct nmk_pinctrl - state container for the Nomadik pin controller + * @dev: containing device pointer + * @pctl: corresponding pin controller device + * @soc: SoC data for this specific chip + * @prcm_base: PRCM register range virtual base + */ struct nmk_pinctrl { struct device *dev; struct pinctrl_dev *pctl; const struct nmk_pinctrl_soc_data *soc; + void __iomem *prcm_base; }; static struct nmk_gpio_chip * @@ -247,6 +241,15 @@ nmk_gpio_disable_lazy_irq(struct nmk_gpio_chip *nmk_chip, unsigned offset) dev_dbg(nmk_chip->chip.dev, "%d: clearing interrupt mask\n", gpio); } +static void nmk_write_masked(void __iomem *reg, u32 mask, u32 value) +{ + u32 val; + + val = readl(reg); + val = ((val & ~mask) | (value & mask)); + writel(val, reg); +} + static void nmk_prcm_altcx_set_mode(struct nmk_pinctrl *npct, unsigned offset, unsigned alt_num) { @@ -285,8 +288,8 @@ static void nmk_prcm_altcx_set_mode(struct nmk_pinctrl *npct, if (pin_desc->altcx[i].used == true) { reg = gpiocr_regs[pin_desc->altcx[i].reg_index]; bit = pin_desc->altcx[i].control_bit; - if (prcmu_read(reg) & BIT(bit)) { - prcmu_write_masked(reg, BIT(bit), 0); + if (readl(npct->prcm_base + reg) & BIT(bit)) { + nmk_write_masked(npct->prcm_base + reg, BIT(bit), 0); dev_dbg(npct->dev, "PRCM GPIOCR: pin %i: alternate-C%i has been disabled\n", offset, i+1); @@ -314,8 +317,8 @@ static void nmk_prcm_altcx_set_mode(struct nmk_pinctrl *npct, if (pin_desc->altcx[i].used == true) { reg = gpiocr_regs[pin_desc->altcx[i].reg_index]; bit = pin_desc->altcx[i].control_bit; - if (prcmu_read(reg) & BIT(bit)) { - prcmu_write_masked(reg, BIT(bit), 0); + if (readl(npct->prcm_base + reg) & BIT(bit)) { + nmk_write_masked(npct->prcm_base + reg, BIT(bit), 0); dev_dbg(npct->dev, "PRCM GPIOCR: pin %i: alternate-C%i has been disabled\n", offset, i+1); @@ -327,7 +330,7 @@ static void nmk_prcm_altcx_set_mode(struct nmk_pinctrl *npct, bit = pin_desc->altcx[alt_index].control_bit; dev_dbg(npct->dev, "PRCM GPIOCR: pin %i: alternate-C%i has been selected\n", offset, alt_index+1); - prcmu_write_masked(reg, BIT(bit), BIT(bit)); + nmk_write_masked(npct->prcm_base + reg, BIT(bit), BIT(bit)); } static void __nmk_config_pin(struct nmk_gpio_chip *nmk_chip, unsigned offset, @@ -693,7 +696,7 @@ static int nmk_prcm_gpiocr_get_mode(struct pinctrl_dev *pctldev, int gpio) if (pin_desc->altcx[i].used == true) { reg = gpiocr_regs[pin_desc->altcx[i].reg_index]; bit = pin_desc->altcx[i].control_bit; - if (prcmu_read(reg) & BIT(bit)) + if (readl(npct->prcm_base + reg) & BIT(bit)) return NMK_GPIO_ALT_C+i+1; } } @@ -1851,6 +1854,7 @@ static int __devinit nmk_pinctrl_probe(struct platform_device *pdev) const struct platform_device_id *platid = platform_get_device_id(pdev); struct device_node *np = pdev->dev.of_node; struct nmk_pinctrl *npct; + struct resource *res; unsigned int version = 0; int i; @@ -1872,6 +1876,20 @@ static int __devinit nmk_pinctrl_probe(struct platform_device *pdev) if (version == PINCTRL_NMK_DB8540) nmk_pinctrl_db8540_init(&npct->soc); + res = platform_get_resource(pdev, IORESOURCE_MEM, 0); + if (res) { + npct->prcm_base = devm_ioremap(&pdev->dev, res->start, + resource_size(res)); + if (!npct->prcm_base) { + dev_err(&pdev->dev, + "failed to ioremap PRCM registers\n"); + return -ENOMEM; + } + } else { + dev_info(&pdev->dev, + "No PRCM base, assume no ALT-Cx control is available\n"); + } + /* * We need all the GPIO drivers to probe FIRST, or we will not be able * to obtain references to the struct gpio_chip * for them, and we @@ -1888,6 +1906,7 @@ static int __devinit nmk_pinctrl_probe(struct platform_device *pdev) nmk_pinctrl_desc.pins = npct->soc->pins; nmk_pinctrl_desc.npins = npct->soc->npins; npct->dev = &pdev->dev; + npct->pctl = pinctrl_register(&nmk_pinctrl_desc, &pdev->dev, npct); if (!npct->pctl) { dev_err(&pdev->dev, "could not register Nomadik pinctrl driver\n");