From: Herton Ronaldo Krzesinski Date: Tue, 2 Nov 2010 00:59:36 +0000 (-0200) Subject: rtl8187: don't set RTL818X_CONFIG3_GNT_SELECT flag on 8187B X-Git-Url: https://git.karo-electronics.de/?a=commitdiff_plain;h=fe3326903d7aafd7b5602d8e178537c8b0465f6c;p=linux-beck.git rtl8187: don't set RTL818X_CONFIG3_GNT_SELECT flag on 8187B The GNTSel bit should only concern pci devices by looking at RTL8180 spec, which is not the case of 8187B. Also testing shows that trying to set this bit fails, a subsequent read from the register after trying to set it shows that the bit isn't set, seems the hardware ignores it, which makes sense. This setting was a left over from Realtek sources. Signed-off-by: Herton Ronaldo Krzesinski Acked-by: Larry Finger Signed-off-by: John W. Linville --- diff --git a/drivers/net/wireless/rtl818x/rtl8187_dev.c b/drivers/net/wireless/rtl818x/rtl8187_dev.c index 2b4ee26c6745..d7ea5d1a2888 100644 --- a/drivers/net/wireless/rtl818x/rtl8187_dev.c +++ b/drivers/net/wireless/rtl818x/rtl8187_dev.c @@ -743,7 +743,7 @@ static int rtl8187b_init_hw(struct ieee80211_hw *dev) rtl818x_iowrite8(priv, &priv->map->EEPROM_CMD, RTL818X_EEPROM_CMD_CONFIG); reg = rtl818x_ioread8(priv, &priv->map->CONFIG3); - reg |= RTL818X_CONFIG3_ANAPARAM_WRITE | RTL818X_CONFIG3_GNT_SELECT; + reg |= RTL818X_CONFIG3_ANAPARAM_WRITE; rtl818x_iowrite8(priv, &priv->map->CONFIG3, reg); rtl818x_iowrite32(priv, &priv->map->ANAPARAM2, RTL8187B_RTL8225_ANAPARAM2_ON);