Linus Torvalds [Thu, 26 Jun 2014 20:06:13 +0000 (13:06 -0700)]
Merge branch 'for-linus' of git://git.kernel.dk/linux-block
Pull block fixes from Jens Axboe:
"A small collection of fixes/changes for the current series. This
contains:
- Removal of dead code from Gu Zheng.
- Revert of two bad fixes that went in earlier in this round, marking
things as __init that were not purely used from init.
- A fix for blk_mq_start_hw_queue() using the __blk_mq_run_hw_queue(),
which could place us wrongly. Make it use the non __ variant,
which handles cases where we are called from the wrong CPU set.
From me.
- A fix for drbd, which allocates discard requests without room for
the SCSI payload. From Lars Ellenberg.
- A fix for user-after-free in the blkcg code from Tejun.
- Addition of limiting gaps in SG lists, if the hardware needs it.
This is the last pre-req patch for blk-mq to enable the full NVMe
conversion. Could wait until 3.17, but it's simple enough so would
be nice to have everything we need for the NVMe port in the 3.17
release. From me"
* 'for-linus' of git://git.kernel.dk/linux-block:
drbd: fix NULL pointer deref in blk_add_request_payload
blk-mq: blk_mq_start_hw_queue() should use blk_mq_run_hw_queue()
block: add support for limiting gaps in SG lists
bio: remove unused macro bip_vec_idx()
Revert "block: add __init to elv_register"
Revert "block: add __init to blkcg_policy_register"
blkcg: fix use-after-free in __blkg_release_rcu() by making blkcg_gq refcnt an atomic_t
floppy: format block0 read error message properly
Al Viro [Mon, 23 Jun 2014 07:44:40 +0000 (08:44 +0100)]
Fix 32-bit regression in block device read(2)
blkdev_read_iter() wants to cap the iov_iter by the amount of data
remaining to the end of device. That's what iov_iter_truncate() is for
(trim iter->count if it's above the given limit). So far, so good, but
the argument of iov_iter_truncate() is size_t, so on 32bit boxen (in
case of a large device) we end up with that upper limit truncated down
to 32 bits *before* comparing it with iter->count.
Easily fixed by making iov_iter_truncate() take 64bit argument - it does
the right thing after such change (we only reach the assignment in there
when the current value of iter->count is greater than the limit, i.e.
for anything that would get truncated we don't reach the assignment at
all) and that argument is not the new value of iter->count - it's an
upper limit for such.
The overhead of passing u64 is not an issue - the thing is inlined, so
callers passing size_t won't pay any penalty.
Reported-and-tested-by: Theodore Tso <tytso@mit.edu> Signed-off-by: Al Viro <viro@zeniv.linux.org.uk> Tested-by: Alan Cox <gnomes@lxorguk.ukuu.org.uk> Tested-by: Bruno Wolff III <bruno@wolff.to> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* patchwork: (11415 commits)
[media] technisat-sub2: Fix stream curruption on high bitrate
[media] au0828: don't hardcode height/width
[media] au0828: Only alt setting logic when needed
[media] au0828/au8522: Add PAL-M support
[media] au8522: Fix demod analog mode setting
[media] au8522: cleanup s-video settings at setup_decoder_defaults()
[media] au8522: be sure that we'll setup audio routing at the right time
[media] au8522: be sure that the setup will happen at streamon time
[media] au8522: move input_mode out one level
[media] au0828: add missing tuner Kconfig dependency
[media] rc: img-ir: Expand copyright headers with GPL notices
[media] V4L2: soc_camera: Add run-time dependencies to sh_mobile drivers
[media] media: mx2_camera: Change Kconfig dependency
[media] media: mx1_camera: Remove driver
[media] V4L2: soc_camera: add run-time dependencies to R-Car VIN driver
[media] rcar_vin: copy flags from pdata
[media] V4L: soc-camera: explicitly free allocated managed memory on error
[media] dib7000p: Callibrate signal strength
[media] dib7000p: Add DVBv5 stats support
[media] dib8000: export just one symbol
...
* v4l_for_linus:
[media] saa7134: use unlocked_ioctl instead of ioctl
[media] media: v4l2-core: v4l2-dv-timings.c: Cleaning up code wrong value used in aspect ratio
[media] si2168: firmware download fix
[media] si2157: add one missing parenthesis
[media] si2168: add one missing parenthesis
[media] staging: tighten omap4iss dependencies
[media] au0828-dvb: restore its permission to 644
When a MC is handled, the correct sbridge_dev is searched based on the node,
checking again later with the assumption the first memory controller found is
the first socket's memory controller is a bogus assumption. Get rid of it.
channel_mask will be used in the future to determine which group of memory
modules is causing the errors since when mirroring, lockstep and close page
are enabled you can't. While that doesn't happen, use the channel_mask to
determine the channel instead of relying on the MC event/exception.
This patch changes the way devices are searched by using product id instead of
device/function numbers. Tested in a Sandy Bridge and a Ivy Bridge machine to
make sure everything works properly.
projects / karo-tx-linux.git / log