From 2adcf194cbf3ec5181efa8e7af180e2c9f1a63e2 Mon Sep 17 00:00:00 2001 From: Michael Hennerich Date: Fri, 21 May 2010 13:20:38 +0000 Subject: [PATCH] Blackfin: SIC: BF537: change default data/error relative priorities Some peripherals might generate an error interrupt shortly after the data interrupt due to the fact that the peripheral isn't serviced fast enough. In most cases this isn't a problem and is expected behavior. This hasn't been a problem on most parts since you simply don't request the error interrupt (or you leave it disabled while there is an expected state) and do the peripheral status checking in the data interrupt. The Blackfin SIC allows people to prioritize data and error interrupts, and the Blackfin CEC allows interrupts of equal or higher priority to nest. The current default settings gives error interrupts a higher priority than data interrupts. So if an error occurs while processing the data interrupt, it will be serviced immediately. However, the error interrupt on the BF537 SIC cannot be enabled on a per-peripheral basis. Once the error interrupt is enabled for one peripheral, it is automatically enabled for all peripherals. Therefore lower the default multiplexed error interrupt priority so most people need not worry themselves with this issue. Signed-off-by: Michael Hennerich Signed-off-by: Mike Frysinger --- arch/blackfin/mach-bf537/Kconfig | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/arch/blackfin/mach-bf537/Kconfig b/arch/blackfin/mach-bf537/Kconfig index d81224f9d723..08b2b343ccec 100644 --- a/arch/blackfin/mach-bf537/Kconfig +++ b/arch/blackfin/mach-bf537/Kconfig @@ -14,8 +14,8 @@ config IRQ_DMA_ERROR int "IRQ_DMA_ERROR Generic" default 7 config IRQ_ERROR - int "IRQ_ERROR: CAN MAC SPORT0 SPORT1 SPI UART0 UART1" - default 7 + int "IRQ_ERROR: PPI CAN MAC SPORT0 SPORT1 SPI UART0 UART1" + default 11 config IRQ_RTC int "IRQ_RTC" default 8 -- 2.39.5