From 41e2b05b9598d6bdf91fc20280bfc538d853f769 Mon Sep 17 00:00:00 2001 From: Rajkumar Manoharan Date: Fri, 20 May 2011 17:52:14 +0530 Subject: [PATCH] ath9k: set 40 Mhz rate only if hw is configured in ht40 Whenever there is a channel width change from 40 Mhz to 20 Mhz, the hardware is reconfigured to ht20. Meantime before doing the rate control updation, the packets are being transmitted are selected rate with IEEE80211_TX_RC_40_MHZ_WIDTH. While transmitting ht40 rate packets in ht20 mode is causing baseband panic with AR9003 based chips. ==== BB update: BB status=0x02001109 ==== ath: ** BB state: wd=1 det=1 rdar=0 rOFDM=1 rCCK=1 tOFDM=0 tCCK=0 agc=2 src=0 ** ath: ** BB WD cntl: cntl1=0xffff0085 cntl2=0x00000004 ** ath: ** BB mode: BB_gen_controls=0x000033c0 ** ath: ** BB busy times: rx_clear=99%, rx_frame=0%, tx_frame=0% ** ath: ==== BB update: done ==== Cc: stable@kernel.org Signed-off-by: Rajkumar Manoharan Signed-off-by: John W. Linville --- drivers/net/wireless/ath/ath9k/rc.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/wireless/ath/ath9k/rc.c b/drivers/net/wireless/ath/ath9k/rc.c index 133502b9c832..c0d0773baa22 100644 --- a/drivers/net/wireless/ath/ath9k/rc.c +++ b/drivers/net/wireless/ath/ath9k/rc.c @@ -689,7 +689,8 @@ static void ath_rc_rate_set_series(const struct ath_rate_table *rate_table, if (WLAN_RC_PHY_HT(rate_table->info[rix].phy)) { rate->flags |= IEEE80211_TX_RC_MCS; - if (WLAN_RC_PHY_40(rate_table->info[rix].phy)) + if (WLAN_RC_PHY_40(rate_table->info[rix].phy) && + conf_is_ht40(&txrc->hw->conf)) rate->flags |= IEEE80211_TX_RC_40_MHZ_WIDTH; if (WLAN_RC_PHY_SGI(rate_table->info[rix].phy)) rate->flags |= IEEE80211_TX_RC_SHORT_GI; -- 2.39.5