From 5c31ef91c06db7800ad573174bd92be4df34ecb2 Mon Sep 17 00:00:00 2001 From: Angelo Butti Date: Mon, 7 Nov 2016 16:39:03 +0100 Subject: [PATCH] 8250: FIX Fourth port offset of Pericom PI7C9X7954 boards Hi, below patch to fix Fourth port offset of Percom PI7C9X7954 boards. I had a problem using Fourth port on a pci express serial board based on Pericom PI7C9X7954. Reading datasheet I notice a "special" offset assign to this port when used in I/O mode. Offset 0x0 -> UART 0 Offset 0x8 -> UART 1 Offset 0x10 -> UART 2 Offset 0x38 -> UART 3 <<---- This don't follow a logical sequence This patch add a different init to last port, to have right offset. I check also Pericom 7952 and 7958 but that devices follow logical sequence, so they are ok. Regards, Angelo Signed-off-by: Angelo Butti Signed-off-by: Greg Kroah-Hartman --- drivers/tty/serial/8250/8250_pci.c | 34 ++++++++++++++++++++++++++++++ 1 file changed, 34 insertions(+) diff --git a/drivers/tty/serial/8250/8250_pci.c b/drivers/tty/serial/8250/8250_pci.c index b98c1578f45a..5aeabf732d74 100644 --- a/drivers/tty/serial/8250/8250_pci.c +++ b/drivers/tty/serial/8250/8250_pci.c @@ -1329,6 +1329,30 @@ static int pci_default_setup(struct serial_private *priv, return setup_port(priv, port, bar, offset, board->reg_shift); } +static int pci_pericom_setup(struct serial_private *priv, + const struct pciserial_board *board, + struct uart_8250_port *port, int idx) +{ + unsigned int bar, offset = board->first_offset, maxnr; + + bar = FL_GET_BASE(board->flags); + if (board->flags & FL_BASE_BARS) + bar += idx; + else + offset += idx * board->uart_offset; + + if (idx==3) + offset = 0x38; + + maxnr = (pci_resource_len(priv->dev, bar) - board->first_offset) >> + (board->reg_shift + 3); + + if (board->flags & FL_REGION_SZ_CAP && idx >= maxnr) + return 1; + + return setup_port(priv, port, bar, offset, board->reg_shift); +} + static int ce4100_serial_setup(struct serial_private *priv, const struct pciserial_board *board, @@ -2095,6 +2119,16 @@ static struct pci_serial_quirk pci_serial_quirks[] __refdata = { .setup = pci_default_setup, .exit = pci_plx9050_exit, }, + /* + * Pericom (Only 7954 - It have a offset jump for port 4) + */ + { + .vendor = PCI_VENDOR_ID_PERICOM, + .device = PCI_DEVICE_ID_PERICOM_PI7C9X7954, + .subvendor = PCI_ANY_ID, + .subdevice = PCI_ANY_ID, + .setup = pci_pericom_setup, + }, /* * PLX */ -- 2.39.5