From 70637a6dcaa6e4cb707d0d50a7ea448f13438786 Mon Sep 17 00:00:00 2001 From: =?utf8?q?Heiko=20St=C3=BCbner?= Date: Tue, 25 Jun 2013 14:55:42 +0200 Subject: [PATCH] pinctrl: more clarifications for generic pull configs PULL_PIN_DEFAULT is meant for hardware completely hiding any pull settings from the driver, so that it's really only possible to turn the pull on or off, but it not being possible to determine any pull settings from software. Also the binding-documentation for the pull arguments did not match the changes to the expected values. Signed-off-by: Heiko Stuebner Reviewed-by: James Hogan Signed-off-by: Linus Walleij --- .../devicetree/bindings/pinctrl/pinctrl-bindings.txt | 5 ++--- include/linux/pinctrl/pinconf-generic.h | 5 ++++- 2 files changed, 6 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt index 2d730e3dd496..7498bdc00e19 100644 --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt @@ -165,9 +165,8 @@ output-high - set the pin to output mode with high level Arguments for parameters: -- bias-pull-up, -down and -pin-default take as optional argument 0 to disable - the pull, on hardware supporting it the pull strength in Ohm. bias-disable - will also disable any active pull. +- bias-pull-up, -down and -pin-default take as optional argument on hardware + supporting it the pull strength in Ohm. bias-disable will disable the pull. - drive-strength takes as argument the target strength in mA. diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h index 10ad996afee4..48aa4ba7b089 100644 --- a/include/linux/pinctrl/pinconf-generic.h +++ b/include/linux/pinctrl/pinconf-generic.h @@ -41,7 +41,10 @@ * impedance to GROUND). If the argument is != 0 pull-down is enabled, * if it is 0, pull-down is total, i.e. the pin is connected to GROUND. * @PIN_CONFIG_BIAS_PULL_PIN_DEFAULT: the pin will be pulled up or down based - * on embedded knowledge of the controller, like current mux function. + * on embedded knowledge of the controller hardware, like current mux + * function. The pull direction and possibly strength too will normally + * be decided completely inside the hardware block and not be readable + * from the kernel side. * If the argument is != 0 pull up/down is enabled, if it is 0, the * configuration is ignored. The proper way to disable it is to use * @PIN_CONFIG_BIAS_DISABLE. -- 2.39.5