From 93a35141826a67b781cd3a4179577eed188cc321 Mon Sep 17 00:00:00 2001 From: Srinivas Kandagatla Date: Thu, 28 Jan 2016 17:43:30 +0000 Subject: [PATCH] arm64: dts: qcom: add correct drive strenght on cs pins 2mA drive strenght is not enough to drive chipselect low on hardware configurations with level shifters, 16mA should give good range to allow such configurations to work. This issue was noticed while testing spi on db410c with sensor board. Signed-off-by: Srinivas Kandagatla Signed-off-by: Andy Gross --- arch/arm64/boot/dts/qcom/msm8916-pins.dtsi | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi index 3bd917e48a8a..c17cd8bd7c9f 100644 --- a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi +++ b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi @@ -82,7 +82,7 @@ }; pinconf_cs { pins = "gpio2"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -116,7 +116,7 @@ }; pinconf_cs { pins = "gpio6"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -150,7 +150,7 @@ }; pinconf_cs { pins = "gpio10"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -184,7 +184,7 @@ }; pinconf_cs { pins = "gpio14"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -218,7 +218,7 @@ }; pinconf_cs { pins = "gpio18"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -252,7 +252,7 @@ }; pinconf_cs { pins = "gpio22"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; -- 2.39.5