From 95a8fde23ef426aeee579bc99f35dc854e711225 Mon Sep 17 00:00:00 2001 From: Jarkko Nikula Date: Tue, 15 Sep 2015 16:26:17 +0300 Subject: [PATCH] spi: spi-bfin5xx: Calculate transfer speed unconditionally SPI core validates the transfer speed and defaults to spi->max_speed_hz in case the transfer speed is not set so code here won't use the chip->baud value (which is derived from spi->max_speed_hz). Please note driver uses chip->baud at the beginning of message transmission by calling the bfin_spi_restore_state() but then programs per transfer speed in bfin_spi_pump_transfers(). I'm not familiar with the HW so I don't know would it be possible to remove chip->baud completely by either using constant value in bfin_spi_restore_state() or by removing the baud register write there. Signed-off-by: Jarkko Nikula Signed-off-by: Mark Brown --- drivers/spi/spi-bfin5xx.c | 6 +----- 1 file changed, 1 insertion(+), 5 deletions(-) diff --git a/drivers/spi/spi-bfin5xx.c b/drivers/spi/spi-bfin5xx.c index a3d65b4f4944..1e91325bf39c 100644 --- a/drivers/spi/spi-bfin5xx.c +++ b/drivers/spi/spi-bfin5xx.c @@ -661,11 +661,7 @@ static void bfin_spi_pump_transfers(unsigned long data) message->state = RUNNING_STATE; dma_config = 0; - /* Speed setup (surely valid because already checked) */ - if (transfer->speed_hz) - bfin_write(&drv_data->regs->baud, hz_to_spi_baud(transfer->speed_hz)); - else - bfin_write(&drv_data->regs->baud, chip->baud); + bfin_write(&drv_data->regs->baud, hz_to_spi_baud(transfer->speed_hz)); bfin_write(&drv_data->regs->stat, BIT_STAT_CLR); bfin_spi_cs_active(drv_data, chip); -- 2.39.5