From c98d3a3cf1a5d36c81148d931184d7681b06d976 Mon Sep 17 00:00:00 2001 From: Tony LIU Date: Fri, 30 Dec 2011 14:32:41 +0800 Subject: [PATCH] ENGR00171027-2 [USB_HOST]after plug in/out on the hub,host can't work This issue will happen only when suspend bit is set but phcd is not set The root cause of this issue is the IC defect. - If the suspend bit is set without phcd bit set, host controller can't resume normally - The workaround is after set suspend bit, we need set the following bit in USB PHY at once: HW_USBPHY_PWD_RXPWDRX HW_USBPHY_PWD_RXPWDDIFF HW_USBPHY_PWD_RXPWD1PT1 HW_USBPHY_PWD_RXPWDENV HW_USBPHY_PWD_TXPWDv2I HW_USBPHY_PWD_TXPWDIBIAS HW_USBPHY_PWD_TXPWDFS - Furthermore, after resume, we must clear these bits during the K state - IC has no plan to fix this issue - This issue only happen on MX6Q/MX28 driver part Signed-off-by: Tony LIU --- drivers/usb/host/ehci-arc.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/usb/host/ehci-arc.c b/drivers/usb/host/ehci-arc.c index bed3056993ce..8db08ba50921 100755 --- a/drivers/usb/host/ehci-arc.c +++ b/drivers/usb/host/ehci-arc.c @@ -155,6 +155,16 @@ static irqreturn_t ehci_fsl_pre_irq(int irq, void *dev) pdata->wakeup_event = 0; fsl_usb_recover_hcd(pdev); return IRQ_HANDLED; + } else { + u32 portsc = 0; + struct ehci_hcd *ehci = hcd_to_ehci(hcd); + portsc = ehci_readl(ehci, &ehci->regs->port_status[0]); + /* PORT_USB11 macro is used to judge line state K*/ + if ((PORT_USB11(portsc)) && (portsc & PORT_SUSPEND)) { + pdata = hcd->self.controller->platform_data; + if (pdata->platform_resume) + pdata->platform_resume(pdata); + } } return IRQ_NONE; } -- 2.39.5