From e62c9ce4a4c0e0ffd5718e962ba4606cd5d0d600 Mon Sep 17 00:00:00 2001 From: Luciano Coelho Date: Thu, 3 Nov 2011 08:44:42 +0200 Subject: [PATCH] wl12xx: use the same SDIO block size for all different chips The sdio driver uses a block size of 512 bytes by default. With our card, this doesn't work correctly because it sets the block size FBR in the chip too early (ie. before the chip is powered on). Thus, if we don't set it explicitly, block mode remains disabled in the chip. If we try to send more data than fits in one block, the sdio driver will split it into separate blocks before sending to the chip. This causes problems because the chip is not expecting multiple blocks. At the moment this is not a problem, because we use chunks of 512 bytes for firmware upload and the data is always sent in byte mode. In the next patch, we will change the chunk size to a bigger value, so this patch is a preparation for that. Signed-off-by: Luciano Coelho --- drivers/net/wireless/wl12xx/main.c | 14 ++++++++++---- 1 file changed, 10 insertions(+), 4 deletions(-) diff --git a/drivers/net/wireless/wl12xx/main.c b/drivers/net/wireless/wl12xx/main.c index b9a3fe497274..aa1c0f3ebeeb 100644 --- a/drivers/net/wireless/wl12xx/main.c +++ b/drivers/net/wireless/wl12xx/main.c @@ -1313,7 +1313,16 @@ static int wl1271_chip_wakeup(struct wl1271 *wl) /* 0. read chip id from CHIP_ID */ wl->chip.id = wl1271_read32(wl, CHIP_ID_B); - /* 1. check if chip id is valid */ + /* + * For wl127x based devices we could use the default block + * size (512 bytes), but due to a bug in the sdio driver, we + * need to set it explicitly after the chip is powered on. To + * simplify the code and since the performance impact is + * negligible, we use the same block size for all different + * chip types. + */ + if (!wl1271_set_block_size(wl)) + wl->quirks |= WL12XX_QUIRK_NO_BLOCKSIZE_ALIGNMENT; switch (wl->chip.id) { case CHIP_ID_1271_PG10: @@ -1343,9 +1352,6 @@ static int wl1271_chip_wakeup(struct wl1271 *wl) ret = wl1271_setup(wl); if (ret < 0) goto out; - - if (!wl1271_set_block_size(wl)) - wl->quirks |= WL12XX_QUIRK_NO_BLOCKSIZE_ALIGNMENT; break; case CHIP_ID_1283_PG10: default: -- 2.39.5