]> git.karo-electronics.de Git - mv-sheeva.git/shortlog
mv-sheeva.git
2009-06-09 Santosh ShilimkarARM: OMAP4: SMP: Add mpu timer support for OMAP4430
2009-06-09 Santosh ShilimkarARM: OMAP4: SMP: Add OMAP4430 SMP board files
2009-06-01 Russell KingMerge branch 'smp' into devel
2009-05-31 Russell King[ARM] Kconfig: remove 'default n'
2009-05-31 Alessandro... [ARM] 5505/1: serial amba-pl011: move to arch_initcall...
2009-05-31 Marek Vašut[ARM] 5522/1: PalmLD: IDE support
2009-05-29 Russell KingMerge branch 'for-next' of git://git.kernel.org/pub...
2009-05-29 Kevin Hilman[ARM] 5529/1: davinci: MMC platform support: DMA_32BIT_...
2009-05-29 Russell KingMerge branch 'for-next' of git://git.kernel.org/pub...
2009-05-28 Tony LindgrenMerge branch 'omap4' into for-next
2009-05-28 Tony LindgrenMerge branch 'omap3-boards' into for-next
2009-05-28 Tony LindgrenMerge branch 'omap3-upstream' into for-next
2009-05-28 Tony LindgrenMerge branch 'omap-upstream' into for-next
2009-05-28 Kevin Hilmandavinci: defconfig update: add EMAC
2009-05-28 David Brownelldavinci: add SRAM allocator
2009-05-28 David Brownelldavinci: soc-specific SRAM setup
2009-05-28 David Brownelldavinci: remove remnants of IRAM allocator
2009-05-28 Kevin Hilmandavinci: cleanup: move dm355 UART2 define to dm355.c
2009-05-28 Mark A. Greerdavinci: Move PINMUX defines to SoC files
2009-05-28 Mark A. Greerdavinci: Add compare register support to timer code
2009-05-28 Mark A. Greerdavinci: Integrate cp_intc support into low-level irq...
2009-05-28 Mark A. Greerdavinci: Factor out emac mac address handling
2009-05-28 Mark A. Greerdavinci: Remove unused i2c eeprom_read/write routines
2009-05-28 Mark A. Greerdavinci: Move emac platform_data to SoC-specific files
2009-05-28 Mark A. Greerdavinci: Move serial platform_device into SoC-specific...
2009-05-28 Mark A. Greerdavinci: Make GPIO code more generic
2009-05-28 Santosh ShilimkarARM: OMAP4: Add defconfig for 4430 SDP
2009-05-28 Santosh ShilimkarARM: OMAP4: Add support for 4430 SDP
2009-05-28 Santosh ShilimkarARM: OMAP4: Clock stubs since CLKDEV not in yet.
2009-05-28 Santosh ShilimkarARM: OMAP4: Add minimal support for omap4
2009-05-28 Grazvydas IgnotasARM: OMAP3: pandora: add support for mode devices
2009-05-28 Syed Mohammed... ARM: OMAP3: Add omap3 EVM defconfig
2009-05-28 Syed Mohammed... ARM: OMAP3: Add omap3 EVM support
2009-05-28 Vikram PanditaARM: OMAP3: Defconfig for Zoom2 board
2009-05-28 Vikram PanditaARM: OMAP3: Add support for OMAP3 Zoom2 board
2009-05-28 Adrian HunterARM: OMAP3: RX51: Connect VAUX3 to MMC2
2009-05-28 Grazvydas IgnotasARM: OMAP3: pandora: setup regulator framework for MMC
2009-05-28 David BrownellARM: OMAP3: Initialize regulators for Beagle and Overo
2009-05-28 David BrownellARM: OMAP3: mmc-twl4030 uses regulator framework
2009-05-28 Tony LindgrenARM: OMAP3: Initialize more devices for LDP
2009-05-28 Imre DeakARM: OMAP3: ZOOM MDK: Add FB support to board file
2009-05-28 Paul WalmsleyARM: OMAP3: SDRC: add timing data for Qimonda HYB18M512...
2009-05-28 Paul WalmsleyARM: OMAP3: SDRC: add timing data for Micron MT46H32M32...
2009-05-28 Vikram PanditaARM: OMAP2/3: Serial: Remove arch_initcall dependency
2009-05-28 Tony LindgrenARM: OMAP2/3: Remove L4_WK_OMAP_BASE, L4_PER_OMAP_BASE...
2009-05-28 Andrew de QuinceyARM: OMAP1: Make 770 LCD work
2009-05-28 Tony LindgrenARM: OMAP: Add some entries to MAINTAINERS
2009-05-28 Imre DeakARM: OMAP2: 2430SDP: Add FB support to board file
2009-05-28 Tony LindgrenARM: OMAP2/3: Add generic smc91x support when connected...
2009-05-28 Juha YrjolaARM: OMAP2/3: Add generic onenand support when connecte...
2009-05-28 Santosh ShilimkarARM: OMAP2/3: sDMA: Correct omap_request_dma_chain...
2009-05-28 Tomi ValkeinenARM: OMAP2/3: DMA: implement trans copy and const fill
2009-05-28 Kevin HilmanOMAP1: PM: update and decouple from OMAP2/3 PM core
2009-05-28 Kevin HilmanOMAP3: PM: prevent module wakeups from waking IVA2
2009-05-28 Kevin HilmanOMAP3: PM: Clear pending PRCM reset flags on init
2009-05-28 Kevin HilmanOMAP3: PM: Ensure PRCM interrupts are cleared at boot
2009-05-28 Peter 'p2'... OMAP3: PM: Ensure MUSB block can idle when driver not...
2009-05-28 Kevin HilmanOMAP3: PM: D2D clockdomain supports SW supervised trans...
2009-05-28 Kevin HilmanOMAP3: PM: Add D2D clocks and auto-idle setup to PRCM...
2009-05-28 Jouni HoganderOMAP: UART: Add sysfs interface for adjusting UART...
2009-05-28 Kevin HilmanOMAP3: PM: UART: disable clocks when idle and off-mode...
2009-05-28 Kevin HilmanOMAP3: PM: Add wake-up bit defintiions for CONTROL_PADC...
2009-05-28 Kevin HilmanOMAP3: PM: Force IVA2 into idle during bootup
2009-05-28 Jouni HoganderOMAP: Add new function to check wether there is irq...
2009-05-28 Kevin HilmanOMAP2/3: PM: push core PM code from linux-omap
2009-05-28 Russell King[ARM] smp: use new cpumask functions
2009-05-28 Catalin Marinas[ARM] 5516/1: Flush the D-cache after initialising...
2009-05-26 Kevin HilmanRevert "ARM: OMAP: Mask interrupts when disabling inter...
2009-05-26 Tony LindgrenMerge branch 'omap-clock-upstream' of git://git.pwsan...
2009-05-26 Mark A. Greerdavinci: Add watchdog base address flexibility
2009-05-26 Mark A. Greerdavinci: Add base address and timer flexibility
2009-05-26 Mark A. Greerdavinci: Move interrupt ctlr info to SoC infrastructure
2009-05-26 Mark A. Greerdavinci: Move pinmux setup info to SoC infrastructure
2009-05-26 Mark A. Greerdavinci: Add support for multiple PSCs
2009-05-26 Mark A. Greerdavinci: Add clock init call to common init routine
2009-05-26 Mark A. Greerdavinci: Support JTAG ID register at any address
2009-05-26 Mark A. Greerdavinci: Encapsulate SoC-specific data in a structure
2009-05-26 Kevin Hilmandavinci: EMAC platform support
2009-05-26 Kevin Hilmandavinci: MMC platform support
2009-05-26 Kevin Hilmandavinci: update davinci_all_defconfig for dm355, dm6467
2009-05-26 Kevin Hilmandavinci: DM646x: add base SoC and board support
2009-05-26 Kevin Hilmandavinci: DM355: add base SoC and board support
2009-05-26 Hugo Villeneuvedavinci: DM644x: add support for SFFSDR board
2009-05-26 Kevin Hilmandavinci: add platform support for watchdog timer
2009-05-26 Sergei Shtylyovdavinci: INTC: add support for TI cp_intc
2009-05-26 Mark A. Greerdavinci: support different UART bases for zImage uncompress
2009-05-26 Troy Kiskydavinci: interrupts: get_irqnr_and_base: save an instru...
2009-05-26 Chaithrika U Sdavinci: use 32-bit accesses for low-level debug macros
2009-05-26 Kevin Hilmandavinci: fixups for banked GPIO interrupt handling
2009-05-26 David Brownelldavinci: gpio irq enable tweaks
2009-05-25 Santosh ShilimkarARM: OMAP: Remove unnecessary omap2_globals.
2009-05-25 Santosh ShilimkarARM: OMAP: Remove useless omap_sram_error function.
2009-05-25 Santosh ShilimkarARM: OMAP: Remove unwanted type casts and fix the compi...
2009-05-25 Tony LindgrenARM: OMAP2/3: Reorganize Makefile to add omap4 support
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP_CM_REGADDR
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP2_PRCM_BASE
2009-05-25 Tony LindgrenARM: OMAP2/3: Move define of OMAP2_VA_IC_BASE to be...
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP_PRM_REGADDR and OMAP2_PRM_BASE
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP2_32KSYNCT_BASE
2009-05-25 Tony LindgrenARM: OMAP1: Misc clean-up
next