#include <asm/gpio.h>
#include <asm/arch/iomux-mx53.h>
#include <asm/arch/clock.h>
+#include <asm/arch/hab.h>
#include <asm/arch/imx-regs.h>
#include <asm/arch/crm_regs.h>
#include <asm/arch/sys_proto.h>
PAD_CTL_SRE_FAST | PAD_CTL_PUS_47K_UP)
char __uboot_img_end[0] __attribute__((section(".__uboot_img_end")));
+char __csf_data[0] __attribute__((section(".__csf_data")));
static iomux_v3_cfg_t tx53_pads[] = {
/* NAND flash pads are set up in lowlevel_init.S */
printf("WDOG RESET detected; Skipping PMIC setup\n");
else
printf("<CTRL-C> detected; safeboot enabled\n");
- return 1;
+ return 0;
}
ret = setup_pmic_voltages();
};
#ifdef CONFIG_LCD
-static u16 tx53_cmap[256];
vidinfo_t panel_info = {
/* set to max. size supported by SoC */
.vl_col = 1600,
.vl_row = 1200,
.vl_bpix = LCD_COLOR32, /* Bits per pixel, 0: 1bpp, 1: 2bpp, 2: 4bpp, 3: 8bpp ... */
- .cmap = tx53_cmap,
};
static struct fb_videomode tx53_fb_modes[] = {
.upper_margin = 2,
.vsync_len = 10,
.lower_margin = 2,
- .sync = FB_SYNC_CLK_LAT_FALL,
},
{
/* Emerging ET0500G0DH6 800 x 480 display.
}
karo_fdt_move_fdt();
- lcd_bl_polarity = karo_fdt_get_backlight_polarity(working_fdt);
if (video_mode == NULL) {
debug("Disabling LCD\n");
lcd_enabled = 0;
return;
}
+
+ lcd_bl_polarity = karo_fdt_get_backlight_polarity(working_fdt);
vm = video_mode;
if (karo_fdt_get_fb_mode(working_fdt, video_mode, &fb_mode) == 0) {
p = &fb_mode;
u8 mac[ETH_ALEN];
imx_get_mac_from_fuse(0, mac);
- if (!is_valid_ether_addr(mac)) {
+ if (!is_valid_ethaddr(mac)) {
printf("No valid MAC address programmed\n");
return;
}
int board_late_init(void)
{
- int ret = 0;
const char *baseboard;
env_cleanup();
} else {
printf("WARNING: Unsupported baseboard: '%s'\n",
baseboard);
- ret = -EINVAL;
+ if (!had_ctrlc())
+ return -EINVAL;
}
exit:
gpio_set_value(TX53_RESET_OUT_GPIO, 1);
clear_ctrlc();
- return ret;
+
+ get_hab_status();
+
+ return 0;
}
int checkboard(void)
karo_fdt_enable_node(blob, "stk5led", 0);
fdt_fixup_mtdparts(blob, nodes, ARRAY_SIZE(nodes));
- fdt_fixup_ethernet(blob);
karo_fdt_fixup_touchpanel(blob, tx53_touchpanels,
ARRAY_SIZE(tx53_touchpanels));
karo_fdt_fixup_usb_otg(blob, "usbotg", "fsl,usbphy", "vbus-supply");
karo_fdt_fixup_flexcan(blob, stk5_v5);
tx53_fixup_rtc(blob);
- karo_fdt_update_fb_mode(blob, video_mode);
-
+#ifdef CONFIG_SYS_LVDS_IF
+ karo_fdt_update_fb_mode(blob, video_mode, "/lvds0-panel");
+ karo_fdt_update_fb_mode(blob, video_mode, "/lvds1-panel");
+#else
+ karo_fdt_update_fb_mode(blob, video_mode, "/lcd-panel");
+#endif
return 0;
}
#endif /* CONFIG_OF_BOARD_SETUP */