Under certain circumstances the ethernet PHY cannot be detected on
Ka-Ro electronics TXUL modules. Using a phy-reset-post-delay of > 5ms
alleviates this problem. Specify a value of 10ms to be on the safe side.
pinctrl-0 = <&pinctrl_enet1 &pinctrl_enet1_mdio &pinctrl_etnphy0_rst>;
phy-mode = "rmii";
phy-reset-gpios = <&gpio5 6 GPIO_ACTIVE_LOW>;
pinctrl-0 = <&pinctrl_enet1 &pinctrl_enet1_mdio &pinctrl_etnphy0_rst>;
phy-mode = "rmii";
phy-reset-gpios = <&gpio5 6 GPIO_ACTIVE_LOW>;
+ phy-reset-post-delay = <10>;
phy-supply = <®_3v3_etn>;
phy-handle = <&etnphy0>;
status = "okay";
phy-supply = <®_3v3_etn>;
phy-handle = <&etnphy0>;
status = "okay";